PDA

View Full Version : Please HELP! My Wing wont turn on!!!

Nolimit1211
10-02-2008, 11:05 AM
Please Help me!

So I Flashed my Wing to a new rom (Open Touch v2.7), and it was working fine for a couple of hours, than it started acting up (Freezing up). so I pulled the battery and let it sit for a while, a little while after, I went to turn it on, and IT WOULDNT BOOT UP AT ALL (stays dead, off)!! After hours of trying to get it to respond, it finally got into bootloader mode and I flashed it back to the Shipped T-mobile Rom, it was working fine for a minute but when I turned it off and went to turn it back on IT WONT BOOT UP AGAIN, It just stays Dead! It doesnt even respond to charging (Unless I somehow get into bootloader mode after hours)

As of right now im continously trying to do a hard resset but it just stays dead and just trying to get it to start up at all, does anyone kno what the problem is Please?!
mv3
10-02-2008, 06:05 PM
the battery?

or you got a lemon..... :'(
gauntman
10-02-2008, 09:06 PM
My Herald got the exact same problem after only 2 months of usage and back then it was still running WM5 stock ROM. I mailed the store I bought it from and got a replacement battery, that solved the problem.
Nolimit1211
10-02-2008, 09:37 PM
i put my battery into a diffirent Wing and it worked fine... do you still think changing the battery will help??
gauntman
10-02-2008, 09:48 PM
i put my battery into a diffirent Wing and it worked fine... do you still think changing the battery will help??

If that is the case, no I don´t think it will help you.

If I read your post right it won´t charge but the chargelight will light up if you get it into bootloader? (tinking about this passage)

It doesnt even respond to charging (Unless I somehow get into bootloader mode after hours)

Have you checked the batteryconnectors? They may be stuck and not quite touching the battery and when you try to hard reset the phone flexes a bit and suddenly you´ve got a connection. Also try and clean the small metal contact surfaces on the battery. As little as a fingerprint may result in a bad connection with the battery.
bugsy714
10-02-2008, 10:10 PM
At least you flashed it back to stock-if it's still under warrenty and the tricks above don't work-send it in for replacement =)
gauntman
10-02-2008, 10:56 PM
At least you flashed it back to stock-if it's still under warrenty and the tricks above don't work-send it in for replacement =)

Unless you used HardSPL and it still in there.
bugsy714
10-02-2008, 11:23 PM
Good point!
loco41
17-02-2008, 06:59 PM
i got the same problem today i flash my wing and i cant turn it on
bugsy714
17-02-2008, 11:03 PM
Do a search for "unbrick"