Possible that olipro 2.40 caused usb sync issues?

[david7586]

Ever since flashing my sprint mogul with the 2.40 bootloader, radio 3.27, and dcd 2.2.6 I've been having problems accessing activesync & the usb connection in the bootloader. Ive tried toggling the advanced connections thing under the settings tab, but that hasnt helped. I feel its caused by either olipro or my usb port somehow hosed right after flashing. It seems to be that the port died, but it just seems so suspicious right after flashing. I have tried 4 computers and each have problems recognizing the usb device. It detects, but cannot assign drivers to it and ends up calling it an unknown device.

Also, do you guys have any issues when hitting the reset button? More often than not, when i reset my mogul will enter the tricolor bootloader screen eventhough i did not touch the power+camera button. I also havent found a reliable way to exit the bootloader other than hitting the reset button until it randomly resets back into loading my dcd firmware.

Any help would be greatly appreciated. It's unnerving nott being able to use activesync or even flash my bootloader back into stock. please help!

[david7586]

I still havent had the activesync issues fixed enenthough i read the thread about using the cab that changes your mobile from using generic rnds to usb serial mode. I would rather know how to stop the erratic olipro behavior. If i hit the reset button on my phone right now, it will likely reset into the bootloader. I dont need to hold the pwr and camera buttons. To get out, it seems i need to have a power cable plugged in and then keep hitting reset until it randomly deceides to boot into the dcd firmware. Ive never seen such bizarre behavior that i can reproduce so cosistently. Any ideas? Please help me, its getting very frustrating. :-(

[david7586]

http://www.youtube.com/watch?v=VjWmmx8ij5Y

This is a youtube video showing what I am experiencing.

I am running olipro 2.40
radio 3.27.00
dcd 2.2.6 which is based off the leacked 3.16 firmware

Basically its a video of me entering the bootloader when i hit the reset button and then me trying to exit the bootloader by hitting the reset button until my mogul randomly restarts into the dcd firmware.

Also, this might belong under the titan upgrading section. If so, could a mod move this thread please?

[aph]

I've had similar problems but they started when I did the upgrade to the leaked 6.0 + GPS ROM from HTC. Later I installed Olipro and it didn't change anything

[kaos420]

i had something close to this.But mine also had charging issue.Turns out the 6800 inherited the same usb issues as the 6700.My pins weren't making contact always.I actually had my unit replaced cause of this.I thought it was a wm6.1 issue as well.but it wasn't.

[david7586]

@ aph

I did install the leaked stock 6.1 right before, but i didnt have issues until dcd 2.2.4. i upgraded to 2.2.6 through the sd card. maybe if we flash back to the non-leaked firmware and upgrade again? Maybe the leaked firmware overwrote someinfo that the latest firmwares dont touch upon?

[david7586]

would you guys mind helping me downgrade my mogul back to stock? just a set of guidelines would be nice. i dont wannt to accidentily flash something in the wrong order and hose my install.