Sorry i'm French Big Problem superCID message in french Help

[inferno2]

Bonjour a tous et désolé d'ecrire en francais mais je ne pense pas me faire comprendre en Anglais!
J'ai acheté un Kaiser aujourd'hui en version Orange et j'ai voulu mettre la Rom officielle HTC.
Je n'ai pas bien suivi le tutoriel pour mettre en super Cid et j'ai coupé avant la fin de la premiere étape donc je n'ai pas fait le dernier transfert!
Je suis donc bloqué sur le bootloader (serial) et je ne peut rien faire! Aucune Rom ne passe!
Je ne peut pas reprendre la procédure du super Cid? je n'arrive pas non plus avec la carte mémoire (hermimg)
A l'aide!
Help Help Help
Thanks

Hello everyone and was sorry to write in French but I do not think I make myself understood in English!
I bought a Kaiser today in Orange version and I wanted to put the Roma official HTC.
I did not quite follow the tutorial to put into super Cid and I shut down before the end of the first stage, therefore, I did not make the last transfer!
So I am stuck on the bootloader (serial), and I can do nothing! None Rom does!
I can not take up the proceedings of the super Cid? I can not with the memory card (hermimg)

[anaethelion]

Je ne comprends pas bien ton souci, tu as branché ton pda a ton pc, tu l'as syncro, tu as lancé la procédure et il a reboot. Mais si tu n'as pas lancé l'utilitaire d'update il devrait encore être sur le bootloader d'origine.

Pourrais-tu être plus précis ?

Et faire des manipulations comme ça sans lire les instructions c'est très mal !

I do not fully understand your concern, you plugged your pda a ton pc, you have syncro, you have started the procedure and he reboot. But if you do not launched update utility should still be on the original bootloader.

Could you be more specific?

And can manipulate like this without reading the instructions is very bad!

[P1Tater]

Don't you say nothin' bad about my momma!!!!!!!!!!!!

Ne pas vous dire quoi que ce soit de mal de ma maman !!!!!!!!!!!!

[inferno2]

Alors a bien compris ledébut j'ai fait la parti *superCid mais pas complete je n'ai pas fait la parti d'update dutout petit fichier et voila mon erreur. Et j'ai ensuite mi la rom HTC FR et elle a été jusqu'a 16% pui blocage et erreur!
Impossible de remettre ni la Rom offricielle, ni celle d'orange, ni de finir le super CID
Voila
MErci
a l'aide

So has understood the beginning I made the device * superCid not complete but I did not make the device update dutout small file and voila my mistake. And then I did rom FR HTC, and was up 16% - blocking and error!
Unable to recover Official Rom nor orange, or finish the super CID
Voila
Thank you
for your help

[anaethelion]

Ok so, i don't think i'm enough skilled in flashing htc's for helping him, so here is the point :

He tried to HardSPL his device but he interrupted the installation before the RUU and never did the update. He then tried to flash an official HTC rom, the flash stuck at 16% he interrupted it again and now his device seems to be stuck on the bootloader.

Any ideas ?
PS : i already told him it was really really bad to not read the HowTo

P1Tater > I promise, i didn't, well, i think... xD

[P1Tater]

Ok so, i don't think i'm enough skilled in flashing htc's for helping him, so here is the point :

He tried to HardSPL his device but he interrupted the installation before the RUU and never did the update. He then tried to flash an official HTC rom, the flash stuck at 16% he interrupted it again and now his device seems to be stuck on the bootloader.

Any ideas ?
PS : i already told him it was really really bad to not read the HowTo

P1Tater > I promise, i didn't, well, i think... xD

what happens if he hard resets

[tomsenna]

Ok so, i don't think i'm enough skilled in flashing htc's for helping him, so here is the point :

He tried to HardSPL his device but he interrupted the installation before the RUU and never did the update. He then tried to flash an official HTC rom, the flash stuck at 16% he interrupted it again and now his device seems to be stuck on the bootloader.

Any ideas ?
PS : i already told him it was really really bad to not read the HowTo

P1Tater > I promise, i didn't, well, i think... xD

This has happened to me several times in the past. Tell him 1st not to worry or panic. I would imagine there may be several situations that can cause this, so this may not be the only answer. In my case, I noticed that before this happened, activesync would connect and disconnect seemingly for no reason. So, I surmized that they could be related and persisted by flashing when it seemed this situation settled down. I'm still not 100% sure why this happens to USB/activesync, but I should follow up on it... someday.

[indiana77]

Comme conseillé par P1Tater, as tu essayé un Hard reset

Pour se faire sur laisse appuyé sur les deux soft key (calendrier et contact) tout en effectuant un soft reset.

As advised by P1Tater, have you tried a Hard reset

To do this press both soft keys (calendar and contacts) while performing a soft reset.

[inferno2]

Merci mais le Hard Reset ne donne rien!
Je ne peut mettre aucune ROM
Quand il démarre il est sur le bootloader et rien d'autre!
Merci d'avance pour vos réponse
Nicolas

In english

le hard reset do nothing!
I can't put any ROM!
When it start i see bootloader only!
Thanks
Nicolas

Did Hard Reset but does nothing!
I cannot put on any ROM
When it starts it is on the bootloader and nothing else!
Thank you in advance for your response
Nicolas

[P1Tater]

I am not totally sure to be honest, the likes of GSLeon3 or jocky would be more apt at helping in this situation. I guess you could try HERE (http://forum.xda-developers.com/showthread.php?p=1765045&highlight=unbrick+phone#post1765045), but like I said, I am not really sure. I have never interrupted a flash for fear of thinkgs like this. I guess you could also go to the rom section and download an untouched rom in .exe format and give that a shot as well, which is HERE (http://wiki.xda-developers.com/index.php?pagename=Kaiser_ROMs). You could also try the section for Hardspl will not install White screen solved which is HERE (http://forum.xda-developers.com/showthread.php?t=354061). Like I said already though, I am not totally sure but I guess they are worth a shot.

[anaethelion]

I'm back, the main problem of this guy is the French Orange TyTN II has it's own rom and orange, as far as i know, never released the original rom on the internet.

So for him it's like if a tilt owner tried to flash an HTC stock rom without having installed the HardSPL at all, i think the solution is around MTTY but since i never used this tool i'm not really sure about that fact... ^^

[inferno2]

Thanks for your answer! on this topic,http://forum.xda-developers.com/showthread.php?p=1765045&highlight=unbrick+phone#post1765045is exactly my problem, when y tried to put HTC's rom, my phone blocked at 16%!!
I download MTTY but i never see "USB port" only "port com..."
Help me please
I used Windows Vista
Nicolas

[anaethelion]

Vérifies que ton kaiser est bien branché en USB (ouais je sais, mais bon) éssayes de débrancher et rebrancher, vérifies aussi que ton firewall laisses passer la connection du téléphone.

En fait vérifies que tout laisses passer la connection, au besoin désactive le firewall le temps de manipuler le téléphone.

Ensure your Kaiser is connected (USB connection tone). Unplug and replug if necessary, also verified that your firewall lets the phone pass through.

If necessary disable the firewall.

[inferno2]

Merci pour toutes vos réponses! j'ai réussi a refaire fonctionner mon tytn!
J'ai réussi a faire fonctionner mtty sur mon deuxieme PC en windows XP!
Et j'ai reussi a recommencer toute la manipulation et a mettre la Rom HTC!
Par contre je n'ai aucune idée si j'ai la derniere ROM?
Comment peut on le savoir? ou se trouve les ROM sur le site HTC car je suis bien inscrit? Et les mise a jour officielle?
Merci
Nicolas

[mikechannon]

Writing in French is OK.
But, our rules say you must give an English translation.
Use Google languages if necessary.

(The quality of the translation is not important!)

Mike

Écrire en français, c'est bon.

Mais, disent nos règles, vous devez remettre une traduction en anglais.

Utilisez Google langues si nécessaire.


(La qualité de la traduction n'est pas important!)



Mike