how to install 2.4 ollipro without activesync

[excess4]

In dcds post with the latest radio he mentions to install the new radio, the new rom, and then upgrade to 2.4 because the latest rom is not compatible with it but my phone keeps rebooting and i cant setup a activesync connection to update to ollipro 2.4 any help asap would be appreciated

[illuminarok]

Load your phone into screen say:

TITA100
SPL-1.20.Olipro

Hold power + camera + soft reset w/ stylus to make a Olipro screen appear.

Next, run unlocker, keep click a "NO" box about 5 times.
Run the rest of the software.

[bmorrisj]

mine stays 1.20 olipro

i know im missing something, this is the first time ive caught a snag flashing my phone.

[excess4]

unlocker 2.4 is a dos prompt theres no place to put no

[ebb]

Reconnect your device to the desktop- that should stop the rebooting- it did for me. Once it stops, you can load 2.40

[excess4]

i understand what you mean now but after it installed the temp one, it took just a second to load ollipro 2.4 with 100%completeion but it still shows 1.2 on my screen after a reset and all as if it never installed.What gives

[excess4]

i load 2.4 and it still keeps 1.2 for some reason,

[bmorrisj]

actually active sync did catch it before it rebooted (with the arrows at the top of the screen) and i was able to run titanunlocker.bat successfully :)

[Ultima99]

I had the same issue before. Just flash a new 1.2 compatible ROM to your phone then it should boot allowing you to reflash 2.4.

[bmorrisj]

I had the same issue before. Just flash a new 1.2 compatible ROM to your phone then it should boot allowing you to reflash 2.4.

and then you're stuck not being able to boot/flash the new radio :(