stack at boot options

[emir_m385]

I was upgrading my Qtek 9090 to WM6 by fallowing the wizard. Everithing was fine up to setting boot options and rebooting step (set "Enable KITL" to "No", "Clean Registry Hive" to "Yes" & "Format Storage" to "Yes"). I changed boot options as instructed and hit "Email" button. After that I am stack at White screen, nothing happens...
After several hours, I reseted my BA, and found that boot options are set to default values (Yes, no, no). I tried to change settings several times, but it just never accepts changes.
Can someone help me? Please?

[jakubd]

Boot options are always presented in default YES/NO/NO - some developer set it so (probably not to make hard reset every time and enable KITL needed for debugging). It's up to you to set is NO/YES/YES to make hard reset and that's all.
If you have white screen later on after formatting the storage and cleaning the hive, you just need to flash again with different (or even the same, if this one is correct) ROM. This is normal in case of broken flash, broken ROM or just wrong ROM.
So: reflash/format/wait :)

[Sheichiro]

when i put it No, Yes, Yes.. it was white like yours.. but I press the e-mail button again n again n i press the other button too.. n viola.. it's about less than a minute it shows the Black crossbow boot screen..

[emir_m385]

I have tried to re-flash with several different images; wm6, wm5 and 2k3, always the same problem! I can't get it to accept new boot options (NO/YES/YES).
Is there any other way?

Please help, my BA is currently useless!