Bricked my Athena but i can enter the bootloader... what do I have to do??

[mauveron]

I used Olipro's unlocker to unlock my device. I completed step 1 without any problem and step 2 seemed to be problem-free too, but at the end, when the status bar reached 100%, the Athena shut itself off and I could not boot normally to complete step 3.

If I power on pushing camera button it enters in the red-green-blue screen displaying that on the red bar at the top of the screen:

ATHE100
IPL-v1.00
ATHE100
SPL-v1.20.Olipro

And on the bottom of the screen, on the white bar, it shows

Serial

If I connect an usb cable, it shows

USB

so it does recognize it.

Now, WHAT DO I HAVE TO DO TO RESTORE MY DEVICE??

Thanks, folks!

[eaglesteve]

Enter the bootloader, connect the usb, then run the romupdateutility on the pc. Before that, make sure your battery is full, and remove storage card.

Good luck.

[Pawel062]

Enter the bootloader, connect the usb, then run the romupdateutility on the pc. Before that, make sure your battery is full, and remove storage card.

Good luck.

yep. also did you remove the sd on the first time? step 3 if i remember correctly flashes u bac to another radio so ur gps works. maybe it should have been in bootloader for step 3. dont remember to be honest what it should look like.

[mauveron]

Thanks eaglesteve, now I have a working AP touch 3.0 on my X7500.

Pawel062, do I have to repeat only step3 to have my GPS working?