PDA

View Full Version : Can't exit bootloader screen

leedavid
10-04-2008, 05:50 PM
Hi,

I tried to upgrade my XDA using Ranju's latest updater, the whole process failed and now I'm stuck at the BL screen "USB" at the top (when connected, otherwise it says "serial") and "v1.00" at the bottom.

My PC, SyncCentre and Windows Mobile Device Centre (I'm using Vista) all show the device as being disconnected (up until trying to upgrade everything had been fine).

As it's not showing up on my PC all of the software options for recovering it dont fail, all end with a plethora of USB not connected errors etc

I've tried the how-to on the wiki: http://wiki.xda-developers.com/index.php?pagename=Uni_Stuck_Bootloader_Serial to no avail.

Does anybody have any ideas? Greatly appreciated,

Thanks,
Lee
mauroc.26
10-04-2008, 10:30 PM
with jasjar-bl1.01-ruu-v1.2 I always restart my JJ Leave your uni in bl and start the application Good luck......

I think the Vista is not the problem this upgrade don't use AS or "in italian centro gestione dispositivi WM"

Bye


M.C.
cfds
11-04-2008, 08:42 AM
Well, I flashed my Qtek a while ago, it failed to flash (using Vista) and doing a hard reset after it whas hanging at the startupscreen(the one with all the rom/radio numbers). No matter what I tried, following the instructions on Vista windows mobile center all failed... The good news is that your computer and your PDA still see when it is connected, ie USB/Serial, like in my case!

I then tried it on my desktop/XP, it flashed without a problem...

The funny bit is that I flashed my herald (WM6) 2 times using Vista without any problem...

I cannot explain but if U have the possibility, try and see if it works on XP...!

Good luck!
pbocsak
14-04-2008, 11:53 PM
are you trying to flash it WITH your SIM card and / or SD card inside? If so, try taking them both out! It worked for me a few times!
ice_coffee
16-04-2008, 05:37 PM
I would start by getting rid of vista !
AngelEyes
18-04-2008, 11:18 AM
i had the same xprience
the different was i downgrade from wm6 to wm5 (i need the vcall)
failed in vista, succeed in xp
-> my advice : try in xp !! don't forget to remove the sd card
KALI2000
18-04-2008, 12:49 PM
Read this post, you have the solution to the problem here:
http://forum.xda-developers.com/showthread.php?t=313001
You need to update the driver manually, if not, will not be able to install the driver.
You need to do this without sd/sdhc and without the sim.
If you follow these instructions, you can flash with success.
Greetings.
Kali.:)