freakingwilly
13-04-2008, 11:42 AM
Well, after hours of research and searching and reading, I finally decided to flash my T-Mobile Wing. Yay! First, I did Hard-SPL from HERE (http://forum.xda-developers.com/showthread.php?t=358225) and followed the instructions to the point. The CanonYang splash screens came up and my Wing loaded into Windows Mobile just fine. From there, I installed ASerg's policies again and ran Itje's Touch-IT Lite for the Wing "1__UPGRADE_ROM.bat" and followed the instructions it prompted me with. An error screen came up on my phone saying "Unknown Status" but I just left it alone. After about 10 minutes, Itje's RUU completed and I hard reset my phone.
Now, only the first CanonYang splash screen comes up and my phone locks up there. Did I just brick my phone? What do I do to fix this?
Any help is greatly appreciated.
*EDIT* In my haste and fear of the "brick", I chose to post a thread rather than do the obvious that many will most likely state. If it helps my situation, please note that it's nearly 5am in Chicago, I have not slept yet, and I'm pretty much terrified I just made a $300 paper weight. I'm certain many of you would do the same. :D
Yes, I did fix my problem... and yes, I found my answer by searching the forums... and yes, I will buy you all cookies! Itje gets a candy bar though :)
Now, only the first CanonYang splash screen comes up and my phone locks up there. Did I just brick my phone? What do I do to fix this?
Any help is greatly appreciated.
*EDIT* In my haste and fear of the "brick", I chose to post a thread rather than do the obvious that many will most likely state. If it helps my situation, please note that it's nearly 5am in Chicago, I have not slept yet, and I'm pretty much terrified I just made a $300 paper weight. I'm certain many of you would do the same. :D
Yes, I did fix my problem... and yes, I found my answer by searching the forums... and yes, I will buy you all cookies! Itje gets a candy bar though :)