Need help upgrading bootloader - 2.03 to 2.10

[samterry1234]

Hi guys, you have been a great help to me so far, but I just can't find anythign to help me with this now. I have a hermes100 with WM6 and i just flashed the radio to 1.54.07 and it gave me an option for hardSPL and said that it was recommended so i investigated and found the upgrade for it.

I ran the wrapper file and it goes to the stage where it puts my hermes into flash mode but it displays "spl1.09" on the screen yet when push the ok and power keys during reset it shows "spl2.03"

it goes through the screens until it puts my phone into flash mode and it says it is trying to read my device then i get error code (260) that it isnt connected. Anyone know a way to fix this?

[ultramag69]

Use sd card method, page 116 on here: http://forum.xda-developers.com/showthread.php?t=296722

Hope this helps...Cheers...:D

[samterry1234]

okay, i tried the sd card method and it does the same thing. after it gets to the bootloader screen i just sits there with

"HERM100
IPL-SSPL by des

HERM 100
SPL-109.ds




serial"

[samterry1234]

okay, nevermind, i just had to reinstall the drivers for when i was in bootloader mode. I got it to work, thank you for you help.

cheers :-D

[ultramag69]

No problem, now you should be able to flash any hermes rom to your hearts content with the knowledge you have a safety net if something does(and probably will, as you'll find flashing addictive, sooner or later) go wrong. Pleae remember though that Hard SPL ISN'T a guarantee that you will be able to fix you phone, it just makes it easier when something goes wrong... Cheers....and happy flashing...:D