Qtek 9100 after rom uprade --> not responding

[dravidek]

I upgrade a ROM by softSPL, after that my qtek in not responding. I Can not to switch it on.

Is there any chance to repaire it???
Please help me.
Thank you so much.

---------------------------------------------------
Qtek 9100 WM5
2.17.0001 IPL/SPL
this is all what i know.

[starkwong]

Maybe you flashed a ROM with G3 IPL/SPL to your G4 Wizard.
In that case, it is a brick and there is no known method to recover unless replacing DoC Chip or mainboard.

[anichillus]

I upgrade a ROM by softSPL, after that my qtek in not responding. I Can not to switch it on.

Is there any chance to repaire it???
Please help me.
Thank you so much.

---------------------------------------------------
Qtek 9100 WM5
2.17.0001 IPL/SPL
this is all what i know.

Take out battery for 5 minutes and then try again to boot it.
Also try if you can get it into bootloader ....but after each procedure take the battery out just to make sure it's not frozen.

[lmd0990]

If ur device is G4 then make sure u not flashed with G3 tools

[dravidek]

thank you so muc for you help. Today morning I was at service and the technican helped me. My main desk in MDA was dead. Service changed the MDA :) I so happy because I have a new MDA.

My MDA have a gwaranty.

[lmd0990]

thank you so muc for you help. Today morning I was at service and the technican helped me. My main desk in MDA was dead. Service changed the MDA :) I so happy because I have a new MDA.

My MDA have a gwaranty.

nice news :)
but did u mean they changed the whole device or only the dead desk?
and u may ask them about jtag pins of wizard's cpu (omap850) , i will appreciate it

[dravidek]

nice news :)
but did u mean they changed the whole device or only the dead desk?
and u may ask them about jtag pins of wizard's cpu (omap850) , i will appreciate it

they changed dead desk only.