Issue of Using Athena Unlocker

[aqzz]

First of All, I am Noob for all this flash phone stuff~~ :(
I was using A-Unlocker last night on my Athena, however the phone got f**ked up

I was able to finish the Step 1 "Flash SPL". After I done with Step 1, here is I got from bootloader 3 Color Screen
ATHE 100
IPL-V1.00
ATHE100
SPL-V1.20. Olipro

and it unlocked Step 2 "Unlock Radio"
after the Step 2 there was a Notice popped up "Your Device must now be unlocked with a program, please configure your device and then connect and sync with Activesync. after doing so, click OK and watch your device screen"
and My phone stop at HTC loading screen, not able to boot to "Window Mobile" system. I did reset phone many times but didn't work.
Please Help Me Out here~~ Tyvm

p.s: I can still boot the phone to bootloader 3 Color Screen

[aqzz]

please help me :)

[eaglesteve]

Your device is okay. You can already proceed to flashing any ROM that is desgined for SPL 1.2. If you want just a good looking ROM, you might want to try PK3.0 ROM. If you want WM6.1, try irus ROM.

If I'm you, I'll skip any rom that uses SPL3.5 for the time being until you're sure there is a mean to come back to SPL 1.2. This mean you should skip AP4.0 for the time being.

To flash one of the SPL1.2 based ROM, remove your storage cards and SIM cards, and ensure your battery is close to full. Then get into Bootloader mode (by pressing down the Camera and poke into the reset hole - hold it down for a good few seconds until you see the tr-colored screen). Then connect your cable until you see USB on the device screen. Then on your PC, start the RomUpdateUtility program and follow the instruction on the PC.

Good luck.

[aqzz]

Thx, man! U Rock!!
Just flash the phone with PK3.0 Rom~ :)