PDA

View Full Version : Problems with official wm6.1 release


Chris08
25th May 2008, 05:51 PM
Hi all,
I have just upgraded to the official WM6.1 release. First everything was working fine, but after a little while phone began to dial numbers like crazy and the device became unresponsive.
Any thoughts?
Has anyone else experienced the same?
Many thanks,
Chris

Dr. Strangelove
25th May 2008, 06:27 PM
If I understand your symptons, I think I had the very same problem some time ago.

http://forum.xda-developers.com/showthread.php?t=384791

I only fixed it by getting a replacement. Later, it turned out that my photo button was 'broken'.

Check all your buttons, maybe the problem is situated there. Maybe not...

bengalih
25th May 2008, 08:06 PM
Hi all,
I have just upgraded to the official WM6.1 release. First everything was working fine, but after a little while phone began to dial numbers like crazy and the device became unresponsive.
Any thoughts?
Has anyone else experienced the same?
Many thanks,
Chris

I think there were other reports of this in one of the two main threads on the official release. Have you installed any other keyboards/SIPs?

I wouldn't blame this on hardware yet, especially if you don't have the problem with other ROMS.

haroldallen
25th May 2008, 09:58 PM
Gents, I also flased the new official rom but have had a number of occassions where the device has stopped responding. Soft reset is the only thing that resolves. Sometimes it freezes, as if it is 'hanging', then suddenly works again. Not sure why. Tried a hard reset but still have same problems. Thinking bout flashing back to the WM 6 rom. Any thoughts?

AllTheWay
25th May 2008, 10:01 PM
Gents, I also flased the new official rom but have had a number of occassions where the device has stopped responding. Soft reset is the only thing that resolves. Sometimes it freezes, as if it is 'hanging', then suddenly works again. Not sure why. Tried a hard reset but still have same problems. Thinking bout flashing back to the WM 6 rom. Any thoughts?

I would flash back to the WM6.1 ROM.

Hard reset before customization. aka At the screen where is says "tap the screen to begin to setup your device."

If that still doesn't work then after you are done with the customization flash the 1.65.16.25 radio and see if that works.

jinxman
25th May 2008, 10:10 PM
skype and tcpmp dont work. lots of freezes and lots of error reports wanting to be sent to microsoft. the most adventurous firmware uograde that i have ever experienced and it ate up the whole of my sunday and it is yet to eat up more of my time.

very irresponsible of htc to release something as unripe as this. i doubtv anything got tested before the release.

bengalih
26th May 2008, 01:24 AM
skype and tcpmp dont work. lots of freezes and lots of error reports wanting to be sent to microsoft. the most adventurous firmware uograde that i have ever experienced and it ate up the whole of my sunday and it is yet to eat up more of my time.

very irresponsible of htc to release something as unripe as this. i doubtv anything got tested before the release.

An application not working is not HTC's fault. This is an OS upgrade and vendors need to upgrade their apps. I don't believe I have found an official/leaked 6.1 ROM that DOES run Skype....only cooked versions.

Chris08
26th May 2008, 01:57 AM
I think there were other reports of this in one of the two main threads on the official release. Have you installed any other keyboards/SIPs?

I wouldn't blame this on hardware yet, especially if you don't have the problem with other ROMS.

Hi,
I installed some other keyboard some time ago. But that was before flashing to this new upgrade. I suppose that they will be gone when doing so.
The thing is that it is working fine for some time, about 10 minutes after i flashed to this new upgrade and it begins to dial numbers.
If I do a soft reset the problem begins when I press any key.
Many thanks for any help!

cobra1122
26th May 2008, 03:20 AM
where do you get the offical wm 6.1?

i go to the HTC website and log into the E-club click phone software updates and nothing happens....

i went to att website and cant find anything im actually talking to an ATT rep now but its prty obvious they have no idea what i am talking about as the girl responded with youll need to plug it into a Microsoft computer,

digitalextremes
26th May 2008, 04:51 AM
Hi all,
I have just upgraded to the official WM6.1 release. First everything was working fine, but after a little while phone began to dial numbers like crazy and the device became unresponsive.
Any thoughts?
Has anyone else experienced the same?
Many thanks,
Chris

I had exact same issues, the device dialed all kinds of numbers, alphabets, etc and would not respond for about 5-7 seconds at random times.

I hear someone got that issue fixed by changing SPL and/or chaning Page Pool size to 16MB.

I hope someone can confirm that and make that a sticky before I revert back to this ROM, I am using 3.02 now.

kavi
26th May 2008, 05:21 AM
I had exact same issues, the device dialed all kinds of numbers, alphabets, etc and would not respond for about 5-7 seconds at random times.

I hear someone got that issue fixed by changing SPL and/or chaning Page Pool size to 16MB.

I hope someone can confirm that and make that a sticky before I revert back to this ROM, I am using 3.02 now.

Didn't change the SPL but changed to 16MB pagepool. The intermittent sluggishness is cured about 90%. Wish there was way to fix this 100%

cbreze
26th May 2008, 05:54 AM
Gents, I also flased the new official rom but have had a number of occassions where the device has stopped responding. Soft reset is the only thing that resolves. Sometimes it freezes, as if it is 'hanging', then suddenly works again. Not sure why. Tried a hard reset but still have same problems. Thinking bout flashing back to the WM 6 rom. Any thoughts?

This is the same issue I had. The freeze ups were driving me crazy. I got rid of it and am very happy camper again.

aquanaut88
26th May 2008, 08:05 AM
The file on rapidshare, SSPL-KAIS.exe may be infected with a virus. Trend identified it containing the PAK_Generic.005 virus/malware. Your mileage may vary...

RPG0
26th May 2008, 09:32 AM
http://forum.xda-developers.com/showthread.php?t=394839

Chris08
30th May 2008, 06:15 PM
I had exact same issues, the device dialed all kinds of numbers, alphabets, etc and would not respond for about 5-7 seconds at random times.

I hear someone got that issue fixed by changing SPL and/or chaning Page Pool size to 16MB.

I hope someone can confirm that and make that a sticky before I revert back to this ROM, I am using 3.02 now.

Has anyone found a solution to this thing as of yet?
I fashed the HardASPL that came with the rom but still same result.
Many thanks,
Chris

_Dejan_
30th May 2008, 10:30 PM
I had exact same issues, the device dialed all kinds of numbers, alphabets, etc and would not respond for about 5-7 seconds at random times.s

I have this problem too. Now Im back on my 6.0 ROM :D

jinxman
30th May 2008, 11:04 PM
An application not working is not HTC's fault. This is an OS upgrade and vendors need to upgrade their apps. I don't believe I have found an official/leaked 6.1 ROM that DOES run Skype....only cooked versions.

i am aware of that. but somehow very popular 3rd party software just should be taken into consideration, not to annoy most of the updaters.

apart from the random unresponsivenesses, crashes and freezes, what i find pretty unacceptable, is that you cannot restore a backup from the old system although i was given backup software from htc itself. and we are talking about an upgrade from 6.0 to 6.1. had they called it 7, i would have understood the incompatibility.

i am new to the windows mobile world, so i guess i need to keep shut and swallow what is being offered as i dont have any other choice yet.

but the future is looking bright and we will look back at these occasions and have a laugh when sometime soon everything will be functioning seamlessly with the linux based android and palm operating systems. i heard that nokia too wants to join the fun. lets see.

for now, i will need to revert back to 6.0