dead wing

[daveoflave]

is there any way to fix a wing that will not power up, wont go into bootloader mode and no lights come on when you plug it in?

[Drobcek28]

Try hard reset via soft button and power button

[Hikey]

is there any way to fix a wing that will not power up, wont go into bootloader mode and no lights come on when you plug it in?

can not enter bootloader...
are you sure about your operation?
turn off, unplug USB, hold camera button then plug USB.

if you can not enter bootloader, the only way is send to HTC service center.

[jockyw2001]

if you can not enter bootloader, the only way is send to HTC service center.
Not true, if there is no serious hw defect I can unbrick it with my "FrankenKaiser" unbricker tool set.

Does your PC prompt you to install drivers if you connect it via USB?

[daveoflave]

yea i dosent do anything when i plug it in

[routine8]

Ive got the same problem... flashing a wing from vista and it totally died. cant get into bootloader, cant get computer to recognize, cant get a peep out of the little guy.

My computer went into standby while flashing the rom, then it went into the bootloader and I tried to re-flash, then the progress bar came on the screen of the wing, then it went kaput for good!

i emailed HTC to see if they would run it over in a bus for me.

[rarce037]

im a newbie to all this i recently bricked my wing nothing turned on no light nothing, then i was reading this post and it does work. wat i did i took out my battery put it back in then i held down the camera button and then pluged in the usb and BOOOMMMMMMMM! it went into bootloader! ahahahahahhahahah. so for all you people out there if i can do it you can too!