Dead Imate, with NO IPL and SPL

[amit.sh.dev]

Hi,
Please help me, as its very urgent. I have been upgrading to various ROM's every now and then. Recently I did a blunder, as While upgrading with One of the ROM (Black Majik) i selected SPL 2.10 instead of Force SSPL and while upgrading USB Connection get lost.

Now I am only getting the Splash Screen showing HTC, when i Hard Reset my phone I do not get IPL and SPL version displayed and it takes my to the Splash Screen again.

Please help me in finding a way i can recover my phone.

Thanks in Advance

Regards

[ultramag69]

Try a hard reset...
If that doesn't work and you have Hard SPL on your phone upgrade using the sd card method.
As for your IPL and SPL, what do you see when you go to bootloader? That shows your IPL & SPL. To get to bootloader press power, OK button next to flywheel and soft reset with stylus. Hold all three buttons until you get to tri-colour screen. That will tell you what IPL & Spl you have.
Cheers...:)

[amit.sh.dev]

Thanx for help. I could get my IPL and SPL info. But still i am not been able to get any rom installed on my device as it get stuck on that tri-color screen and rom up gradation wizards comes with different rom looks for activesync connection with the device. I am not been able to boot my device so that i can upgrade it to specific rom. Is there any way i can install a ROM without having active sync connection with the device...

Pl.. Pl.. Pl.. help. I would be greatfull to you

[ultramag69]

IF you have flashed Hard SPL on your phone you have a good Chance... :D
If you haven't and its under warranty you might be able to get them to fix for you. :(
Assuming you have Hard SPLed your phone, try the sd card method - format up to 2gb sd card fat32. copy the .nbh file from the rom upgrade to the sd card.Rename the .nbh file to "hermimg.nbh". Reset phone. As you keep going into bootloader you wont have to manually do that. It should recognize the os flash and prompt you to hit the power button to proceed...

PLEASE NOTE - THIS WILL ONLY WORK IF YOUR SPL IS 2.10 OLIPRO...


Hope you upgraded your SPL cos you will only have a paper weight otherwise..
Best of luck. Cheers...:)