ruud schothorst
15th June 2008, 02:30 PM
Spent several hours to find a thread but coul not find it . I got a new X01HT from Hong Kong that was flashed to English. All seemed to work fine but now when I push the video call button or the comm. mngr button I can see the screen for about one second and than it dissapears and the screen goes back into the start mode. This make it very difficult to make a call and that is what the unit suppose to do. Also when I try to open a picture from the storage card it open for aout one second and goes back in the file mode where I can see all the other picture files. Any suggestion will be appreciated i
The specs of my unit are:
Rom: 3.54.707.3
Romdate: 07/05/07
Radio version: 1.47.00.10
Protocol: 32.80.7020.20H
WM 6 build 17944.0.3.1
IMEI: 35315101635
Storage card 2 GB
I have already done a softreset and several times a hard reset and after that a sync with PC. but no good result. Also tried to check what SPL is on the unit and pushed OK + power + reset but could not see any SPL info. Just saw
M 05
S 04
B 06 and in the middle D.3.54
In a flash I also saw some other information but that was to short to see what that was.
Thanks for any feedback
Ruud
The specs of my unit are:
Rom: 3.54.707.3
Romdate: 07/05/07
Radio version: 1.47.00.10
Protocol: 32.80.7020.20H
WM 6 build 17944.0.3.1
IMEI: 35315101635
Storage card 2 GB
I have already done a softreset and several times a hard reset and after that a sync with PC. but no good result. Also tried to check what SPL is on the unit and pushed OK + power + reset but could not see any SPL info. Just saw
M 05
S 04
B 06 and in the middle D.3.54
In a flash I also saw some other information but that was to short to see what that was.
Thanks for any feedback
Ruud