Problem with Xplode wm6.11 Upgrade

[Moon105]

Hello

PPC: Blue Angel T-Mobile GER
Rom: Xplode Wm6.00.00.WWE
Radio:1.15.00
Protocol: 1337.45

From this rom i want to upgrade to Wm6.1 from Xplode.
My Upgrade steps:
1. Bootloader
2.The ppc shows "Serial"/"Usb" and "v2.05"
2.2 Kill Active sync
3. starting MaUpgradeUt_noID
4.MaUpgradeUt_noID gives no informations about the current Rom /upgrade rom
5.Next
6. Error 150

What i have to do?
Plx help me

Sry for my bad english!

Thx to all

[smuvva]

Try using Windows XP rather than using Vista.

I got the same problem with my XDA IIs,

I tried it in Windows XP and successfully Updated to WM 6.1

[Moon105]

i have Windows XP no Vista

[crossi]

Give it a try without killing ActiveSync on PC.

1. Put device in bootloader mode

2. Put device in the cradle

3. Start update program (wait till 100% and do not remove device out the cradle)

4. When update has finished, hard reset the device
- If you have a PH20B device such as MDAIII, QTEK 9090, XDAIIs, PDA2K etc, EITHER:
Quickly press "Record" & "Camera" before the versions appear at bottom right
OR press "Power" & "Camera" & "Record" buttons and Reset at the same time

- If you have a PH20B1 device such as SX66:
Quickly press "Record" & "Windows Media" before the versions appear at bottom right EITHER
OR press "Power" & "Windows Media" & "Record" buttons and Reset at the same time

You'll see three options on screen. You must change the second and the third to yes. If you are not developing/testing software you can disable the first debug option for better performance.(“Enable KITL” must be NO, “Clean Registry Hive” must be YES, “Format Storage” must be YES)

- If you have a PH20B device such as MDAIII, QTEK 9090, XDAIIs, PDA2K etc, use "Camera" and the "Record" buttons.

- If you have a PH20B1 device such as SX66, use "Windows Media" and the "Record" buttons.

Note: The "Record" button moves up and down the menu and the "Camera" button toggles Yes/No. When you're done, press the button in the middle of the D-Pad to continue booting.

- Press the "Mail" button. A white screen will show for 30 seconds, while it is clearing your device in preparation for the new ROM to start executing
When the bootscreen, aka. the colored stripes is displayed, wait more, you are booting. The welcome screen to set up your device will appear shortly ...
(if removed earlier) Put back your SD Card before you do the setup. This way the installation from the SD will continue after you have done the setup

5. Your upgraded ROM is now running!


Greets Rossi