1ibandit
25th July 2008, 08:18 PM
I have been going through the forums for a while and still not sure what to do...
8125 G4
IPL 2.25.0001
SPL 2.25.0001
GMS 2.25.11
OS 10.0.0.10
I turned it off last night at 68% bat. I turned it on today and it is stuck on the Win 6.1 Diamond Edition splash screen. I have soft reset it many times. The on/off button doesn't work so I have to remove the bat. to shut it off. I did some reading and some say it could be the batt. needs a jump start. I am not sure about this because when plugged into the computer it takes a charge.. light starts out yellow, and later turns green..( i think that is charged)
I don't want to do a hardrest until I hear that is what I have to do.. I have seen others with problems close to mine and a hardrest failed. I am able to do the softrest holding the camera button to get the bootloader screen and would like to reload the rom ( if I have to) but I used SoftSPL to load the Diamond rom and not sure I can reload it without runing SoftSPL again.
I tried to follow the loading steps for using SoftSPL, but the program it tells me to use WST v4.22 and it doesn't see the Wizard. so... can someone tell me if I can use the bootloader screen to reflash my wizard or do I have to do something else..
Thank you
or any other steps to fix this problem
I also need to add that actsync will not connect.. it doesn't see the device...
8125 G4
IPL 2.25.0001
SPL 2.25.0001
GMS 2.25.11
OS 10.0.0.10
I turned it off last night at 68% bat. I turned it on today and it is stuck on the Win 6.1 Diamond Edition splash screen. I have soft reset it many times. The on/off button doesn't work so I have to remove the bat. to shut it off. I did some reading and some say it could be the batt. needs a jump start. I am not sure about this because when plugged into the computer it takes a charge.. light starts out yellow, and later turns green..( i think that is charged)
I don't want to do a hardrest until I hear that is what I have to do.. I have seen others with problems close to mine and a hardrest failed. I am able to do the softrest holding the camera button to get the bootloader screen and would like to reload the rom ( if I have to) but I used SoftSPL to load the Diamond rom and not sure I can reload it without runing SoftSPL again.
I tried to follow the loading steps for using SoftSPL, but the program it tells me to use WST v4.22 and it doesn't see the Wizard. so... can someone tell me if I can use the bootloader screen to reflash my wizard or do I have to do something else..
Thank you
or any other steps to fix this problem
I also need to add that actsync will not connect.. it doesn't see the device...