WM6.0 SIP client configuration - Not working

[kk2202]

WM6.0 SIP client configuration - Not working

--------------------------------------------------------------------------------

Hi all,

I have followed the procedure in
http://forum.xda-developers.com/showthread.php?t=299950 and now i get Internet calling enabled in my device. However i could not make call. I am using the ondo SIP server for testing, no real service provider. I have tried many times and am not successful in getting it work.

However my doubt now is can the SIP client be configured in any of the three WM6.0 Operating system. It has 3 flavours :
1. WM6.0 Classic
2. WM6.0 Professional
3. WM6.0 Standard.

Can the SIP client be unlocked and worked from all the three or any specific flavour only ?

I think those who have made it work can provide insights into it. This is quite important for me. As till now i have been testing with WM6.0 professional. We intend to buy a WM6.0 device, so which flavour should we opt for ?

Hoping to get an earliest positive response.

[tramuyo]

im goin to be honest:

1. WM6.0 CLassic --> It works, but speakerphone sound (no earpiece)
2. WM6.0 Proff--> Same as classic
3. WM6.0 Standard--> Works bcoz says Internet Calling not available but when I configure a working server, it freezes my device at startup, so I have to hardreset it

Clear voice, Good responsiveness. So WM6.0 VoIP is quite good

[kk2202]

I am using a LAN setup . Server used in Ondo server. But then my SIP client does not get registered with the server. Is it possible to try making calls using direct IP without any servers involved ?

[taitan733]

kk2202,

Are you using any firewall at the SIP Server's machine?
I think you need to open SIP port (UDP 5060) at the firewall or disable it.
I'm using Ondo server (aka Brekeke SIP Server) without any problem.

[MsVibe]

Hi, did you make a _setup.xml with your settings and manage to install it?
If not make sure your phone is application unlocked and then follow the instructions again.

I'm successful on WM 6.1 Standard

You might also check for the Prov0Settings file and attach your xml here for verification.
My NAT creates problems for my Sipura 2100 box, but my softphones including the WM6.1 client gets through it without problems. For this reason I don't think your issues are NAT related. You might see the searching state, however when the IP phone icon appears in the top bar you should be good to go.

[MsVibe]

I might also add that if you suspect NAT issues you could try Fring www.fring.com/cab it is really easy to setup. If that works then it's clearly a configuration issue.

[kk2202]

Hi,

I have attached the _setup.xml for verification. 192.168.0.101 is the machine where the ondo SIP server is running.

What should i check in Prov0Settings in this file. It gets created when i install my .cab file.

[kkp]

Hey guys,

Im new to the XDA developer site, recently i have upgraded my Imate Jas Jam from WM5(Telestra) to WM6(3 Network) using "HERM_DOPODASIA_WWE_3.54.707.3_6275_CustomRUU" I have downloaded fring from www.fring.com/cab

Installation is successful, but when i start Fring it simplay shows up the screen which says fring is loading then close application, tried too many times could'nt make this to work, any ideas...

your help is appreciated:)