Upgraded a Bell HTC6800 - phone & data dont work

[profets]

Hi All,

I've got an htc 6800 from bell. upgraded the bootloader to 2.47, radio to 3.42.50 , and installed DCD's 3.2.5

everything went smooth. installed the Bell Carrier cab to get the data settings on the phone.

i've run into 2 problems:
-When trying to use data over the cell network it shows it cannot connect.
-When trying to make a phone call it gets a busy signal immediately

any ideas at all? i've installed the official htc/bell rom and i get the exact same behaviour

thanks

[nitro66215]

Hi All,

I've got an htc 6800 from bell. upgraded the bootloader to 2.47, radio to 3.42.50 , and installed DCD's 3.2.5

everything went smooth. installed the Bell Carrier cab to get the data settings on the phone.

i've run into 2 problems:
-When trying to use data over the cell network it shows it cannot connect.
-When trying to make a phone call it gets a busy signal immediately

any ideas at all? i've installed the official htc/bell rom and i get the exact same behaviour

thanks
I'm assuming you did the programming sequence? I'm not sure if Bell is *228 with option 1 like verizon... but have you tried that?

[profets]

I'm assuming you did the programming sequence? I'm not sure if Bell is *228 with option 1 like verizon... but have you tried that?

nope. i have no idea about that.. how would that sequence work?

with a cdma phone like this, is there any way to know the phone number which should be attached to the phone? is there a way to program the phone number back into the phone ?

[nitro66215]

nope. i have no idea about that.. how would that sequence work?

with a cdma phone like this, is there any way to know the phone number which should be attached to the phone? is there a way to program the phone number back into the phone ?
That's in the EPST settings. Look at ##778 or ##778#. That should bring up EPST settings. If you "View" it has the number in the phone set there. If you "Edit" I believe you can change it.

[profets]

thanks for the replies.. basically got me to figure out what was missing.

for bell it seemed to be ##111111# and it sent it into the settings where you put phone number and stuff.. works perfect now

thanks!

[nitro66215]

thanks for the replies.. basically got me to figure out what was missing.

for bell it seemed to be ##111111# and it sent it into the settings where you put phone number and stuff.. works perfect now

thanks!
Good deal.