USB to PC on Kaiser Possible?

[JeckyllHavok]

Hi there,
tried the new darkforces rom for Kaiser which had the USB to PC in it.
Would like to use it on other Roms, too.
Anyone knows where to get the cab?

Thank in advance

[BlackBull]

did you mean wm5torage?

[stanip]

Give this a try... It works pretty well on my TytnII and X7510.

http://www.nuerom.com/BlogEngine/page/nueMassStorage.aspx

[JeckyllHavok]

NueMassStorage

--------------------------------------------------------------------------------
Give this a try... It works pretty well on my TytnII and X7510.

http://www.nuerom.com/BlogEngine/pag...ssStorage.aspx
Today 03:57 PM



Great man, thanks it's like the app of Diamond and opal.
I'll it a try

[ADB100]

Give this a try... It works pretty well on my TytnII and X7510.

http://www.nuerom.com/BlogEngine/page/nueMassStorage.aspx

Just tested on my Kaiser with (almost) stock WM6.1 ROM and it doesn't work.... It amost does; Windows discovers the hardware and says a new USB disk has been connected but it can't see the contents and says the drive is 0-bytes in size.
When I installed the .cab of WM5torage (with the CardExport II drivers) I had the same behaviour. I know the Kaiser isn't on the list of supported devices (only the Titan and Vogue are listed) but it would be great if this was fixed.

This is pretty much the last thing I need to make my ROM complete.....

Andy

[sheltem]

I've used Nue's USB to PC utility through a cooked rom on my Sprint Touch and while it worked fine, the transfer speeds were slow; approximately 500kb/s transfer rate.

[BlackBull]

same problem with my kaiser.
wm5torage doesnt work too.

[stylez]

CardExport it's not free but been the only way on Kaiser\Tilt to have mass storage, the device is missing a driver that CardExport has.