View Full Version : Microphone BIG problem.
neonq
22nd September 2008, 07:06 PM
Hello,
I got problem with microphone in my HTC HERMES. Without any reasons microphone stop working. Everythink is fine, i can call and do voince records, and then i got call or i just want to do voice note and nothing beside noise is recording. I dont know why it happining. After some time all back to normal, i can call and they hear me, also my voice note are loud and clear. My radio is 1.16. I reinstal my software to PDACornerPro.V25.NonRBSN.Opera. I did do HardReset and this mike problem always come back.. WHY? How make it work correct?
PLEASE HELP ME
MikeChannon
22nd September 2008, 08:44 PM
Hello,
I got problem with microphone in my HTC HERMES. Without any reasons microphone stop working. Everythink is fine, i can call and do voince records, and then i got call or i just want to do voice note and nothing beside noise is recording. I dont know why it happining. After some time all back to normal, i can call and they hear me, also my voice note are loud and clear. My radio is 1.16. I reinstal my software to PDACornerPro.V25.NonRBSN.Opera. I did do HardReset and this mike problem always come back.. WHY? How make it work correct?
PLEASE HELP ME
Well sounds like it might be hardware. If you've done a few hard resets and tested before installing any software and the problem is still there sometimes, then I'd say it's hardware.
The m/board on the Hermes is not one that you can really work on with ordinary soldering tools. A repair shop could check by using a heat gun to check the contacts on the Mic. If that fails then it's likely either the mic coil or a problem with the contacts at or coming from the USB connector.
Mike
neonq
22nd September 2008, 09:44 PM
I say something more. Now i hear myself on voice note but really quiet like 1/10 normal volume.
MikeChannon
22nd September 2008, 11:24 PM
I say something more. Now i hear myself on voice note but really quiet like 1/10 normal volume.
Yes, but even with an open circuit / damaged coil, cracked connection, you can sometimes have sufficient leakage current to get a faint response from things like microphones and speakers. I still think it's probably hardware - but thoroughly check all the software possibilities eg clean install, stock ROM etc.
neonq
23rd September 2008, 12:37 PM
Hm i open hermes but im noob in that stuff:) so everythink look fine for me with microphone. I clean that think to protecting microfone. The problem of couse dont disappear. But.. its look like always when I plug in usb to spv, microphone start working fine.. Not always but moust of time it is solution.. If it is a hardware what i should to recommand to replace in service? Microphone?
skeeve666
23rd September 2008, 05:01 PM
ignore me, re-read what you put and decided i was a nab
vBulletin® v3.8.7, Copyright ©2000-2012, vBulletin Solutions, Inc.