Few Questions After Reading the Wiki Tutorials

[QuantamPulse]

I have an AT&T Tilt and would like to flash the firmware to the HyperDragon III which can be found in this thread.

http://forum.xda-developers.com/showthread.php?t=397121

Following the directions in the TILT Specific Wiki, I flashed the HardSPL which was version 1.57.502.2. This was the file listed in the thread for the TILT.

Checking out the other threads in this forum, it looks like there are now HardSPL version in the 3 range like 3.07 3.28 3.29.

I'm confused if the file listed on the TILT Wiki was correct or if I actually need a different HardSPL file.

My other question is about Radio. I have read all the information about making sure that the radio on my phone will work with the rom that I would like to install.

What I cant seem to find though is how to check what radio my phone is currently using ?

Any help on this would be appreciated.

I know that answers are probably in the forum somewhere I just can't seem to find the right search string to pull it up.

[cheetoh]

Use the HardSPL found here: http://forum.xda-developers.com/showthread.php?t=396922 (this is a sticky on the ROM dev page).

Here is a guide for Radios: http://forum.xda-developers.com/showthread.php?t=393182 - basically flash a radio onto your device and test it out. Different radios will give you better/worse battery life, affect connectivity, GPS, and the like. Performance varies by region and what ROM you have installed.

Here is another link you may find useful: http://wiki.xda-developers.com/index.php?pagename=Kaiser_Radio

Hope this helps.

[QuantamPulse]

So the newer versions of the HardSPL have the same benefits as the one I installed said it did ? Such as being able to go back to older, original roms and helping to protect against bricking ?

[DaveShaw]

So the newer versions of the HardSPL have the same benefits as the one I installed said it did ? Such as being able to go back to older, original roms and helping to protect against bricking ?

The 3.* versions of Hard Spl do the same as the 1.* versions - they allow you to flash cooked Roms. The 3.* have better compatability with WM6.1 than the 1.* versions, thats all.

Ta
Dave

[QuantamPulse]

Another question, I am trying to flash the new 3.56 HardSPL before installing the new Rom.

Do I need to use the SoftSPL even though I already have the 1.5x HardSPL installed or can I just run the update like normal.

Also, when trying to run the update like normal using the KaiserCustom RUU File, I run through the wizard and after getting my phone information it correctly shows that I currently have 1.5x, however it says that I will be updating to 1.00.000.0

Is this normal ? Or should it actually show that it is updating to 3.56 ?

[sd73ta]

yes thats normal one quick thing search for jockeys security unlocker that has saved many headaches

[deepod]

Hi, the youtube video below walks you through it

http://www.youtube.com/watch?v=ezZ-2lHi3T8&NR=1

:D