mayur9890
26th October 2008, 08:31 PM
hello guys,i recently bought a used o2 exec with 2 batteries(one extra old used battery) and pretty much disappointed with it,coz its almost like a dead one,its always turning off even when its fully charged,it stays for max 4-5 mins of work and tends to turnoff suddenly(the image is fading slowly and blackens up ending).then only remedy is to plugin charger in order to start it again.i had tried both batteries,but same problem occurs again.....now in the forum there are various methods for recaliberating battery.
1st) method says recalibration using bootloader mode drain method-it doesnt works as even in bootloader mode my exec turns off automatically even if battery % is much higher(60%,50% etc).
2nd)recalibration using plastic tape covering on one of the battery points in order to drain battery==same automatically turns off even when 70-80% battery left
now what i just want from you guys is a simple answer to my question-should i consider my exec as a brick & stop using it
or
take 1 more chance & buy a new battery.& try it on my device,i think this may not be a battery problem as battery calibration is also not workin,may be its a device hardware problem......
1st) method says recalibration using bootloader mode drain method-it doesnt works as even in bootloader mode my exec turns off automatically even if battery % is much higher(60%,50% etc).
2nd)recalibration using plastic tape covering on one of the battery points in order to drain battery==same automatically turns off even when 70-80% battery left
now what i just want from you guys is a simple answer to my question-should i consider my exec as a brick & stop using it
or
take 1 more chance & buy a new battery.& try it on my device,i think this may not be a battery problem as battery calibration is also not workin,may be its a device hardware problem......