PDA

View Full Version : [Problem] Water..


claxroma
30th October 2008, 01:05 AM
Hi,
I've a little problem.. yesterday the rain shocked my htc p3651..
Today I was able to make a backup (it works 'cause I tried with wm6 emulator).
Now when I turn on my pda I see the RGB screen and:

POLA*** MFG
SPL-2.20.Olinex
CPLD-2

and if there's the MicroSD inserted it tells "No Image File!" for a while.

I tried with hard reset: I held both lower buttons with the stylus in.. then I released the stylus helding buttons.. but no hard reset.

I really don't know what I've to do.. please help me!
Thanx

Hyden121
30th October 2008, 01:11 AM
It sounds like the rain caused your device to short na dump the rom. I would try to reflash your phone with a rom of your choice and see if that works. Make sure that you take the battery off and blow dry it for a while to ensire that it is dried out. Good luck.

claxroma
30th October 2008, 01:21 AM
It sounds like the rain caused your device to short na dump the rom. I would try to reflash your phone with a rom of your choice and see if that works. Make sure that you take the battery off and blow dry it for a while to ensire that it is dried out. Good luck.

Thanx 4 the answer. Please can u tell me a guide for reflashing it? It's the first time and I don't know where I've to begin from.. :(

Hyden121
30th October 2008, 01:29 AM
Well the tri colored screen is the boot loader screen. If you are using Vista then launch windows mobile device center and plug in your phone. Download a rom and launch it. It should hopefully read your device. Then just click next through the rest of the prompts and see if you can get that rom on there. If you are using windows XP then you will need to launch Active Sync. It really is fairly simple after you do it the first time... If your device is not unlocked then you need to fsearch the forums to find out how to unlock it.

claxroma
30th October 2008, 01:36 AM
Well the tri colored screen is the boot loader screen. If you are using Vista then launch windows mobile device center and plug in your phone. Download a rom and launch it. It should hopefully read your device. Then just click next through the rest of the prompts and see if you can get that rom on there. If you are using windows XP then you will need to launch Active Sync. It really is fairly simple after you do it the first time... If your device is not unlocked then you need to fsearch the forums to find out how to unlock it.

Thanx again. I use XP and let me ask to you the last question: is it possible to do it directly from MiniSD?

Hyden121
30th October 2008, 01:55 AM
I know there is a way to flash a rom from the mini sd card but I have never done it. Search the forums. I know I have seen it covered there.

pepeng_kalywete
30th October 2008, 10:37 AM
go to xda-wiki and click on polaris. there youll find what your looking for.

claxroma
30th October 2008, 12:22 PM
I tried.. with 2 or 3 ROMs (original too) but still start with bootloader..
I've done it from MicroSD 'cause USB doesn't work.. does it nees some particular drives? Now is Microsoft USB Sync..

Thanx a lot

pepeng_kalywete
31st October 2008, 05:35 AM
so you cant enter bootloader? but you have activesync 4.5 installed on your pc?