Hard Reset caused...

[robiscool]

Hi All, I did a hard reset today on my phone and ever since the call buttons have changed.

I have some bad pictures of what has happened but I tried to reset it another 2 times after it went like this and it didn't correct the problem.

Does anyone have any ideas? Maybe editing the registry?

Its like the buttons don't have the 3d stand out effect but its as if they are pushed in if you get me?

[robiscool]

I just wanted to add that I have tried changing themes and the problem still exists.

[ai6908]

Which ROM are you using?

[robiscool]

The Rom is 2.15.502.3

I havent been able to update using the usb or micro sd method so I am stuck with the old rom

[ultramag69]

Did you have Hard SPL V7 installed on your Hemes?
Did you format the sd card fat32 and was it 2Gb or less?
Did you rename the .nbh file to Hermimg.nbh?

These 3 things are the major reasons the sd card method fails....

Go to page 116, post 1160 of this thread to use the sd card method to install Hard sPL - http://forum.xda-developers.com/showthread.php?t=296722

Cheers...:D

[robiscool]

I did all of those :P

It just gets stuck on the tri color screen.

Thanks :)

[ultramag69]

At bootloader (tri-colour screen), whats the SPL?
Also, I can't say this enough, make sure that the sd card has been formatted FAT32 . Best if done in a card reader through windows, not through the phone.
I've had people swear that they had and then posted later that it was only formatted FAT. :rolleyes:
Double check that the .nbh file has been renamed hermimg.nbh too.
These are little things but will screw up any effort to flash.:(

Cheers...:D

[xooku]

what device are you using?
if not supercid then cid must match rom when you flash?

read this (http://wiki.xda-developers.com/index.php?pagename=Hermes_Upgrades) again

[ultramag69]

xooku, thats why we install Hard SPL.... It effectively superCIDs your Hermes. If you have it, it doesn't matter what CID you had previously..

Cheers...:D

[robiscool]

I have done all this countlessly, It still goes to the Tri Colour screen, Says loading.. for a split second and then it goes back to the tri colour screen.

Does the card have to be completly erased apart from the hermimg file?

[ai6908]

I have done all this countlessly, It still goes to the Tri Colour screen, Says loading.. for a split second and then it goes back to the tri colour screen.

Does the card have to be completly erased apart from the hermimg file?

yes completely format the card first. Then load the card with the HERMIMG.nbh and flash. Let us know if it works.

[ultramag69]

It would be if you had formatted it FAT32 just before flashing... Back it up 1st though.