bootloader mode and i can't flash with another rom

[cRaZyzMaN]

Hello

i tried to flash my prophet with a portuguese rom with wm6


Now prophet is in bootloader mode and i can't do nothing

what can i do?

i tried

NVID_RUU

and it doesn't update

[NEO130]

Go back to a WM5 Rom.

[cRaZyzMaN]

i already done that

but i still can't update for a rom with wm6

i have

ipl 2.15
and
spl 2.20

it's a g4

[NEO130]

You must read about SoftSPL or HardSPL - Than you can flash a WM6 Rom.

[deltav13]

1. Instala a Rom original do teu aparelho existe o link ai no site.
2. Faz um update a rom com a do pda mobiz (updaterom) é o nome do ficheiro.
3. Faz o hardspl g3, é o mais habitual mas vê no teu aparelho.
4. Instala a nova rom com a g3 ou g4 (RUU) update utility.
Se tiveres dúvidas diz ok, um abraço. :D

[sten_xda]

1. Instala a Rom original do teu aparelho existe o link ai no site.
2. Faz um update a rom com a do pda mobiz (updaterom) é o nome do ficheiro.
3. Faz o hardspl g3, é o mais habitual mas vê no teu aparelho.
4. Instala a nova rom com a g3 ou g4 (RUU) update utility.
Se tiveres dúvidas diz ok, um abraço. :D

can you write / translate this in english please ?

I have the same problem with my prophet and need some instructions to flash

thx in advance

[deltav13]

Charge your device for 2 hours first.
Second enter boot loader mode 3 colours by pressing the com button on the left side of the device, wait.
1. Install the original rom
2. Do a update rom use pda MOBIZ STEP 2 update rom file wait...
3. After do a hard spl G3 or G4 depends on your device.
4. Wait until the device enters again into boot loader mode.
5. Install the new Rom and wait for the device to reeboot.
6 If all goes well you can now use WM6. :D

[cRaZyzMaN]

i already solve this

thanks to all

[machold]

Charge your device for 2 hours first.
Second enter boot loader mode 3 colours by pressing the com button on the left side of the device, wait.
1. Install the original rom
2. Do a update rom use pda MOBIZ STEP 2 update rom file wait...
3. After do a hard spl G3 or G4 depends on your device.
4. Wait until the device enters again into boot loader mode.
5. Install the new Rom and wait for the device to reeboot.
6 If all goes well you can now use WM6. :D

OK, my problem is bigger than this. I can get to the CMONEX page but no further; just hangs there. ALSO, active sync won't connect; tries to but gives up.

The problem? I installed a custom ROM off ppcgeeks.com; it seemed to work well, then it started doing funny things, like not allowing me to access pages; giving me errors messages, etc. I did a soft reset; it hung on the 1st page showing Touch Diamond. Also, won't sync. Did a hard reset (the only way that works for me is to soft reset, quickly press power + vol down while flipping the phone over until the Cmonex page comes up).

Phone hangs there; can't sync it with PC (xppro) anymore (no problems before).

QUESTION: is my phone effed?