HELP! T-Mobile MDA screen going loco

[saddam]

Hi, peeps. Would like to ask for your assistance in troubleshooting my old T-Mobile MDA - the one that is also the Xda mini S.

The unit in question is 2nd hand although it was still in good shape when I got it. Used it for over a year already and has seen much use. Once, the insides got wet and I had to dry it out but it was okay after that. Although the keyboard wasn't showing any backlight until I figured out that a blowdryer would help remedy that situation (after careful dismantling).

Recently, the screen when you slide open the keyboard either comes up blank (whole screen is just white) or is discolored and a bit disaligned (the top part is either missing or is at the bottom of the screen). It happens too on the normal layout at times.

I upgraded the firmware with the most recent one I downloaded here last year. No problems experienced though with regards to the OS and not sure if the recent problem can be attributed to it.

Any ideas and suggestions?

[SammiBoi]

I got the same problem on with the screen my Cingular 8125. When I slide the keyboard open, the exact same thing happens to my screen. Sometimes It only used to happen maybe once every 10th time, but as of last, it is happening all the time.

I spoke to someone at a repair store in Toronto and the guys said it will cost close to $100 to replace some wiring in the back. It didn't seem worth it for me so I got another phone instead, but I would love to keep using this phone if this could be replaced.

[themitch]

Hey guys. If you are comfortable, I would suggest dismantling the phone and taking a look at the ribbon connector between the board and the screen. My guess is that it is loose, or damaged. Reseat the ribbon and try again. Otherwise I would see if replacing the screen helped. Certainly much cheaper than a new phone...

[night-mayor]

first of all check out the socket (on board) where the screen coaxial cord is plugged in , r all the connector pins alligned or are any bent / pulled back ?
in that case reset pins location using a tiny neidle or pin, also use a double faced adheisive tape on the back of the screen connector to rest it tight to keyboard (original setup only they use glue).

second check out if the screen does that if was flipped using software , if it was a hardware case and upper solution wouldnt help then check to see if the sliding mechanism (two plastic identical bars screwed by two screws each to the top and the buttom of the screen) are aligned and screwed tigh to the screen.

now the wizard hardware is a survivor but any tampering with it require tight reseating , screwing and later reflashing (even if the software showed unaffected).