Upgrade ROM code error - Please try again

[harrysaab]

Hi

I had hardspl olinex 1.40/1.24 and it got flashed properly with 3 roms, now i changed the rom again through the phone, hold voldown + back key to run the flash file, but it stopped at 60/65% and nothing happened for 10mins, so i pressed the red reset button to reset the phone, and i get the message on bootloader screen saying PSOC-Diam STAGE_PVT v0x30 Upgrade ROM code error Please try again (in the green bar).

anyone knows how to fix this problem?
i did the hard reset but still no luck :(

did i brick the phone?

anyone had this problem before or got a solution?

thanx in advance.

[cloudedhopes]

if you're stuck in the bootloader... then the only way out is flash via Custom RUU... do this... press the rest and vol down + power... without being connected to the computer... you'll see the bootloader appear... plug in the usb to your computer... and then run the Custom Ruu to flash a rom... should do the trick!

[okokur]

i think, you are the second person with this rom and this fault/mistake.

and as resolve i read the same anwer but with not so much points between the words .... :-)

[harrysaab]

thanks, sorted!

[abhishek.vij]

Sorry for pulling this thread back to life.. but even i am getting the same error :(

I also went to the service center guys but they said its normal and not an issue

[dibbutz]

Sorry for pulling this thread back to life.. but even i am getting the same error :(

I also went to the service center guys but they said its normal and not an issue

Hi

I had hardspl olinex 1.40/1.24 and it got flashed properly with 3 roms, now i changed the rom again through the phone, hold voldown + back key to run the flash file, but it stopped at 60/65% and nothing happened for 10mins, so i pressed the red reset button to reset the phone, and i get the message on bootloader screen saying PSOC-Diam STAGE_PVT v0x30 Upgrade ROM code error Please try again (in the green bar).

anyone knows how to fix this problem?
i did the hard reset but still no luck :(

did i brick the phone?

anyone had this problem before or got a solution?

thanx in advance.

install the original rom 1.93 and after you try again to install step 1 of unlock (the hard spl)