amart79196
20th March 2009, 05:57 PM
Well, I have looked around and found winCE Cab manager as I have googled and searched. There is not just a easy "Answer" that I was able to find, although there might be one right in front of my face.
So, if some can KINDLY just tell me how to make a simple cab, just to change a registry edit, I would be happy.
Just an example as this is a madeup reg keystring:
HKLM-system-htc-software-blah-blah-blah, in key touch, value is set to 0, but I want my cab, once installed to change that value to 1.
I also want to be able to revert back to the original setting if I was to remove the cab.
So, for the short and skinny answer, is there an easy way to make this happen?
will i have to use the WinCE cad maker software, or, do I need something else??
I want my cab to be able to run on my Sprint TouchPro running WM 6.1.
Thanks in advance for the help. And thanks to everyone who refrains from telling me to search as they didn't read the top of my post. Thank you.
So, if some can KINDLY just tell me how to make a simple cab, just to change a registry edit, I would be happy.
Just an example as this is a madeup reg keystring:
HKLM-system-htc-software-blah-blah-blah, in key touch, value is set to 0, but I want my cab, once installed to change that value to 1.
I also want to be able to revert back to the original setting if I was to remove the cab.
So, for the short and skinny answer, is there an easy way to make this happen?
will i have to use the WinCE cad maker software, or, do I need something else??
I want my cab to be able to run on my Sprint TouchPro running WM 6.1.
Thanks in advance for the help. And thanks to everyone who refrains from telling me to search as they didn't read the top of my post. Thank you.