Problem with TouchFlo 3D

[rdware]

Hi,
i've already try to search for my problem but i didn't found any response.

After the install of the new rom and the restore of the backup (by SPB Backup) the touchflo 3d is not be able to run.

The message "touch the screen to boot touchflo 3d" will appear, if i touch the screen it try to start but after it return to the message of touch the screen.

Somebody knows what i can do?

PS: sorry for my english

[mugglesquop]

did u do a hard reset after flashing the ROM?

if you did, then i would suggest re-flashing the ROM, and check it works before restoring data.

[rdware]

i've trying many combinations...

Re-flash and restore nothing
hard reset and restore nothing
re-flash, hard reset and restore nothing

It work fine only if i don't restore the system data... but when i flash this rom i've used the same backup file and it works fine!

However i've trying to restore (after re-flash or hardreset or both) a old backup file... nothing!

i think that If i found the way to reinstall only the touchflo 3d, i can resolve my problem... but i don't found anything about!

[Singelton]

iv had a similar problem i applied my backup disabled tf3d and applied a tf3d.cab found somwhere in this forum cant remember which version might not been on here at all. it was nearly 3 months ago. good luck

edit: here it is: http://www.4shared.com/file/55125558/b8076ddd/HTC_TouchFLO_3D.html