Desperate: Vogue Problems

[Viper Matrix Wireless]

Today, V7 of 6.5 came out & I thought i'd try it.

Before I had ran gps 2.31 coke bootloader to install & V6 installed perfectly.
Realized it did not support MMS, so I went back to the stock rom on USCC.
Problem started where V6 looked corrupted it got stuck during the flash which I then used another computer. It worked fine but looked corrupted till I went back. Everything returned to normal. Now here is the problem like I said today I loaded the non-gps 0.41 bootloader. That was a mistake. I went to V7 & it would not stop restarting it would sit there on until I ended up going to a menu like start or hit the green key then restart. Now i'm frustrated. So I go back to the stock & no change it looks corrupt. I went back to V7 then back to stock rom & it wont install. Gets stuck at 31%. Now nothings there & it wiped my radio 3.42.30. This is after V7 installed but it wont go past smart mobility. It shows a red no radio. What do I do I know how to get into bootloader but I need the radio to flash. I dont know where to get it. Please post steps so I wont continue to mess up more of the device.

Thanks.

[atoz350]

What you need to do is to flash the .40 bootloader found here (ftp://up.ppcgeeks.com/Vogue/Users/ImCoKeMaN/Vogue_unlocker.exe), then a radio ROM. Bell's ROM comes to mind. It can be found here (http://www.htc.com/us/supportdownloadlist.aspx?p_id=70&act=sd&cat=all). DO NOT LET CUSTOMIZATIONS RUN! At this point, your phone is locked.

Next, flash 2.31 CoKe found here (ftp://up.ppcgeeks.com/Vogue/Users/ImCoKeMaN/Vogue_unlocker_MFG_2.31.exe). After that is done, put it into bootloader (Power+Camera+Stylus) then flash V7.

[Viper Matrix Wireless]

Problem: This is what happened

11% - Blanked went back into bootloader mode, Went back into setup
31% - Stopped
Error 262 - Update Error

[Shidell]

Can you successfully flash a carrier's OEM ROM?

[Viper Matrix Wireless]

No all carrier roms always freeze with error 262.

Custom Roms flash but do not go past the 2nd screen after all the information is shown in red.

[Shidell]

How long have you let it sit at that screen? Additionally, have you pulled the battery and let the phone sit for a minute or so before trying to flash again?

[Viper Matrix Wireless]

ive tried letting it sit longer

[s10onn2o]

enter the bootloader and tell me what it says

[Viper Matrix Wireless]

VOGU100
SPL-0.41.CoKe
CPLD-3

[s10onn2o]

when you reset the device what does it do

[Viper Matrix Wireless]

Shows HTC Mobility then the bell logo then no radio in red appears & freezes

[s10onn2o]

im going to have to go for a bit, couple of things to try. if you can get it to boot with a custom rom or stock you need to do the old relocker then do your stock rom if you can't get out of bootloader ill be home tonight to give you a hand.

[s10onn2o]

Shows HTC Mobility then the bell logo then no radio in red appears & freezes

plug it into the computer and see if active snyc will pick it up if so relock

[Viper Matrix Wireless]

Custom rom loads successfully it resets the phone & freezes even if i install a radio on it beforehand nothing responds & I cant change the bootloader version it shows it loads successfully but same version comes back.

Activesync wont recognize since it cant boot into WM.

[Viper Matrix Wireless]

Before all of this started I loaded 0.41 then installed V7 it would stay on as long as it was idle when i went to go do something it reset every time. It stayed on when I was in activesync n connected to usb so I tried going back n well it did the same thing. Now a red light comes on flashes before the green power light

[atoz350]

OKAY!!

Try flashing this: ftp://up.ppcgeeks.com/Vogue/Users/ImCoKeMaN/roms/RUU_Vogue_SPRINT_WWE_1.12.651.1_2.13.00_SPC_NV133_ Ship.exe

It will re-lock your phone with a non-gps ROM. DO NOT LET CUSTOMIZATIONS RUN!!

After you are done it should boot up. Once it boots up, run the 2.31 unlocker found here (ftp://up.ppcgeeks.com/Vogue/Users/ImCoKeMaN/Vogue_unlocker_MFG_2.31.exe). Then flash V7.

Good luck!

[Viper Matrix Wireless]

PROBLEM SOLVED!

I did flash the sprint rom & flashed 2.31!
Went back to USCC stock ROM

NEW PROBLEM!

3.42.30 is my radio now theres a few conflicting issues I have NO SERVICE.

It shows an x under the arrows & a tower with a circle cut in half.

Theres no ESN!

I have:

ROM Version: 3.01.573.4
ROM Date: 10/10/08
Radio Version: 3.42.30
Protocol Version: DCAAXAM-4350H
Hardware Version: 0001
PRL Version: 15052
PRI Version: 1.32_027
Browser Version: MSIE 6.0
ESN: 00000000

How do I fix this?

[atoz350]

PROBLEM SOLVED!

I did flash the sprint rom & flashed 2.31!
Went back to USCC stock ROM

NEW PROBLEM!

3.42.30 is my radio now theres a few conflicting issues I have NO SERVICE.

It shows an x under the arrows & a tower with a circle cut in half.

Theres no ESN!

I have:

ROM Version: 3.01.573.4
ROM Date: 10/10/08
Radio Version: 3.42.30
Protocol Version: DCAAXAM-4350H
Hardware Version: 0001
PRL Version: 15052
PRI Version: 1.32_027
Browser Version: MSIE 6.0
ESN: 00000000

How do I fix this?

For that you'll have to call your customer support service and have them re-provision your phone. You are on USCC's rom now, correct?

Did you let the customizations run on the Sprint ROM?

Try hard re-setting to see if it will re-provision itself before calling.

[Viper Matrix Wireless]

Yea I did by accident.

ive tried hard-resetting.

[atoz350]

Yea I did by accident.

ive tried hard-resetting.

Re-flash your USCC ROM, and let the customizations run on that one. Your phone needs specific files to run on your network.

[Viper Matrix Wireless]

done it twice still the same.

It boots with phone off indicator & i have to turn it on & goes to no service.

Does this on any rom its all the same.

[atoz350]

Flash USCC's ROM, then install this: USCC (http://dcd1182.n715dp.com/index.php?dir=carriers%2F&download=dcd+USCC+Carrier+20080801.cab)

[Viper Matrix Wireless]

Made no difference still the same.

[atoz350]

I know it's a pain in the ass, but try starting over, but this time not letting customizations run on the Sprint ROM. I'm going to give you another ROM to flash after that one from Bell.This will upgrade your radio to 3.42.50 and enable GPS. Don't let customizations run. Use your stylus and soft reset it before the customizations start.
After you are done with those, run the 2.31 unlocker, then run 6.5v7. Forget about your factory ROM. Once done flashing install that carrier cab in my previous post.

The ROM is at this link: http://www.htc.com/us/SupportDownload.aspx?p_id=70&cat=2&dl_id=98

[Viper Matrix Wireless]

I did this an hour ago actually.

[Viper Matrix Wireless]

PPST.EXE freezes in customizations n reboots.

EPST shows no DEC or HEX.

[atoz350]

PPST.EXE freezes in customizations n reboots.

EPST shows no DEC or HEX.

On which ROM?

[Viper Matrix Wireless]

On all roms

[atoz350]

Okay, I'm officially confused. The only thing I can tell you to do, is to run the .40 unlocker/re-locker and run your original ROM. You phone should re-provision itself then. This would be returning it back to the way it was when it was bought. If it doesn't work call your customer service line and have them re-provision your phone. Once it is working, repeat the steps to properly unlock the phone, upgrade the radio, flash the ROM of your choice.

[Viper Matrix Wireless]

I need super cid unlocker.

Original rom wont install on 0.40 only on 2.31

[s10onn2o]

were do you stand right now im off work tonight get yahoo messanger and get a hold of me we'll start from the beginning and work your way up.\
screen name s10onn2o

[Viper Matrix Wireless]

Running Stock USCC ROM now.

Fixed ESN, HEX, DEC. Used CDMA Workshop.

But still nothing I was running alltel ROM beforehand.

Wireless Radio won't configure properly & malfunctions on any ROM Custom or Stock. Showing NO SERVICE.

PPST.exe freezes on custimations. Skipping customizations does not help.

Tried several & several roms custom & stock does not fix.

Everythings fine but the wireless radio doesnt matter if it upgrades or degrades radio.

Using coke 2.31. Note: Had flashed 1.04 of sprints rom on 2.31 but it had malfunctioned due to only installing on .40

Wireless radio phone settings wont save either.

Havent installed a radio individually. not in 3.xx.xx. I have version 1.49.10 & 2.xx.xx I forgot.

SuperCID Unlocker I heard will fix the problem. But can't get it.

[atoz350]

SPL .40/Super CID unlocker:

ftp://up.ppcgeeks.com/Vogue/Users/ImCoKeMaN/Vogue_unlocker.exe