HELP Stuck in Bootloader screen

[motowiz]

I was trying to upgrade my device and then my PC stop working and reboot. Now My Qtek 2020 is showing Serial v1.02 (if not in cradle) and USB v1.02 (if in cradle) and I cannot perform an upgrade because HimaUpgradeUt doesn't detect the device. How can I revert this situation, is it possible?

[Jadel]

More info needed:
Did you already begin to update your QteK? Did your PC say "updating" with a red progress bar and a percentage amount? If so, I think you would need to try and get that cable working again. Perhaps redownload the ROM (the installer may have become corrupted) and make sure that ActiveSync is switched OFF. Perhaps even reinstall ActiveSync if nothing else works. THe cable may also not be getting enough power. Try plugging it into the USB on the back of your computer if it is plugged into a USB Bus or the front USB port. THe back port will give you the most power. Also, make sure it is plugged in to the AC adapter while you upgrade just to make sure your phone doesn't go flat.

If you had not started upgrading it, try reseting your phone using the reset button with the stylus.

[demajek]

:confused:

Hi, I've got the same issue................

Any hope?????????????