PDA

View Full Version : USPL - is there a way to check that process successfully finished?


gemini2201
18th May 2009, 10:15 PM
Hello,
I have spv m650 branded with orange. Have successfully removed simlock, but cid-lock removing with "Wizard Service Tool" failed.
So I was trying to bypass CID lock with USPL.
However I thing something went wrong.
I started start_uspl.exe and followed steps with documentation.
Phone rebooted with blank (black) screen. (ok so far)
According to info at wizard active sync should be connected (green) while flashing. However my phone didn't show it's connected while boot mode.
I've waited about 10mins and decided to continue. After next steps wizard show info that now will start flashing and it take about 10mins. But it took only about 5 seconds... After that wizard showed that finished. And my phone started with normal mode.

So I'm totally unsure if this succeded or not, and since I don't want to brick my phone I'm a bit scared about flashing my system - because I'm not sure if CID is bypassed/removed or not.
I'm searching forum, but I can't find any info how to validate if process is successed or not.

Current SPL version is 1.11.0000 (Unfortunetly haven't checked it before flashing) So I don't know if there is any change or not.

So anyone could please told me if can I safely flash new rom to my phone? Or sth went wrong with USPL and CID-LOCK is still active?

Regards

Zecanilis
18th May 2009, 11:45 PM
IF SPL is 1.11.000' then is CID unlock