View Full Version : Ultra bricked my Tytn !
Freeheld
15th June 2009, 10:53 AM
I need your help
My tytn is bricked
The Bootloader shows me HERM200 IPL-1.01 (White font, Red line)
HERM200 MFG SPL-1.01 (Yellow font) Redline)
I cant connect with my active sync anymore
The OS do not boot anymore
It shows my "no gsm"
It freezed by Windows Mobile Screen !
What can i do ?
Can anybody repair it ?
My english ist so bad, i come from Germany. SRY
I hope anybody can help me
Freeheld
mikisonata
15th June 2009, 01:36 PM
press these buttons together: side ok button, power button and reset button,
then the HTC will go in USB mode and use some rom to flash it
Freeheld
15th June 2009, 03:39 PM
thx for ur answer
when i try to flash it says me Error connecting
actice sync doesnt find my Tytn no conection
the tytn goes to the grey flash screen and interrupt it
can anybody tell my the right ROMs ?
i need a german roms and german radio rom
Freeheld
15th June 2009, 04:42 PM
i have found my bricked Type
SPL HTC_BOOT Boot OS? No GSM? KITL
1.01MFG <=0107 No Yes ---
Diagnostic
bricked while flashing radio
Solution
Flash any type2 radio in NBF format, run RUU 2 times. If that doesn’t work, flash the radio using HERMflasher
i cant find "type2 radio roms in NBF format"
How i can see my HTC_BOOT ?
I crashed my tytn so hard
Freeheld
15th June 2009, 05:39 PM
A new problem
Microsoft ActiveSync cannot recognize this device for one reason:
*The device was not connected properly.
.
.
.
And so one
How i can flash an new right ROM ?
JR_de
15th June 2009, 11:00 PM
You can flash from the SD-Card:
http://wiki.xda-developers.com/index.php?pagename=Hermes_SDCardFlashing
Here are the radio ROMs:
http://wiki.xda-developers.com/index.php?pagename=Hermes_ExtractedRadioRoms
Freeheld
22nd June 2009, 06:12 PM
Thx but it doenst worked
i get an error
Loading...
than cant find file
but i renamed it write ???
Freeheld
22nd June 2009, 06:43 PM
how i can see that i have hardSPL
i dont beleave that i have it
and i cant install it because my activsync doenst work
ultramag69
23rd June 2009, 11:19 AM
If you're using XP - untick "Allow USB Connections" in activesync on pc. Put Hermes into bootloader and run the flash for Hard SPL V7. If this works then try an sd card flash for a different rom. No guarantees it will work but at this point, what have you got to loose?
Good Luck...
Freeheld
28th June 2009, 09:26 PM
it doesnt work very well
i get an UPDATE ERROR
hmmmm
active sync is unticked (USB)
Freeheld
28th June 2009, 10:10 PM
i have found a problem
i had flasched the bootloader 1.01MFG without SuperCID now i get Level= FF in mtty.exe, so i can flash back to 1.04 to install HARD SPL
How can i come back to 1.04 ?
vBulletin® v3.8.7, Copyright ©2000-2012, vBulletin Solutions, Inc.