PDA

View Full Version : [17JUN09 21728 WWE] Ipaq 914c - test version!


parkhaus
17th June 2009, 03:20 AM
So, getting a lot of help from keyx (thank you so much!) I just cooked a ROM with the latest HP update drivers (1.01.01) and the 21728 XIP and SYS from his 614 kitchen.


PROBLEM IS, SOME THINGS ARE NOT WORKING YET (e.g. HARDWARE KEYBOARD).

So consider this version only a test version for now. Any feedback is greatly appreciated. Unfortunately, it has gotten very quiet around here about the 914c (except keyx, who does not own a 914c :( )

1) I do not take any responsibility. I am total newbie (noob) at cooking, this is one of my first ROMs actually.

2) I recommend you to update ALL the sections of the 914c before flashing this ROM. Check here how to do it:
http://forum.xda-developers.com/showthread.php?t=517094
(go to http://www.mediafire.com/download.php?jyzy00y2yal and start update - remember to backup your data before and also your original language ROM using pdocread - plenty of tutorials around here!)


3) get an SD-Card (2GB or lower) and format it to FAT32. Then put the flash.dio on it, hold the sidebuttons VOL-UP and OK, keep holding them and press RESET. When SDloader appears, release. After a few seconds, update progress shows. Wait for about 10minutes until update is finished.

4) after quite a long time, a "tap-screen-to-setup" appears.


Known problems:
- the keyboard is not working at all

If you have read all of the above, download the FLASH.DIO file here:
http://www.mediafire.com/?sharekey=35e55448f15316734c17ca8801618ef7e04e75f6 e8ebb871

parkhaus
17th June 2009, 03:21 AM
reserved for more.....

keyx
17th June 2009, 07:22 AM
I posted in Montecristo thread already but I post here again, you need to use 91x .rom and .vm folder in SYS, I am not sure if they are xip related but you should try using those two folders from Montecristo 21500 rom

parkhaus
17th June 2009, 10:48 AM
I exchanged .ROM and .VM in SYS folder, but the keyboard is still not working.
The driver name for the keyboard is mainstoneii_keypad_Us.dll. Also in the HKLM/HARDWARE/DEVICEMAP/KEYBD the drivername is correct... strange...