Reset vector for porting ipaq 910c

[u20090617]

I've been reading the forums but the information seems fragmented. Is there a single source that describes the reset vector, bootloader start-end address, ram start address, etc.?

I'd like to either replace the bootloader if the current loader sources are not available or use the current loader to bootstrap a non-windows image.

I just need to understand the board bring-up basics.

Any help would be great.

[u20090617]

After looking further I found the processor docs here: http://www.marvell.com/products/cellular/application/PXA27x.jsp

Anyone know if HP has a custom asic such that the addresses are not the same as what is listed in the processor doc?

What is the best jtag to use on this processor? I'd like to be able to flash and load to ram directly with the jtag.

[keyx]

unfortunately this is way too advance that I don't think anyone can answer you...
Beside tinker boot loader can really brick your device..I would rather figure out how does wm os image got load up. May be you can check other htc device forum in xda to see if any of them can load android directly without using another loader(haret) although I think right now haret is still the only option