Problem with USPL - dead after trying to CID unlock

[ClockEr]

I CID unlocked my HTC 3300, and instaled original HTC WM6.

It worked, but it was with 2.xx.xx radio, so I decided to upgrade it to 3.34.90

I started USPL (because i read in this forum that it need to be done before upgrading radio) and command prompt window with "initialisation" (or something like that) worked fine, until 100%. Than it started to upgrade ROM. It also finished to 100%, and then reported an error.

Since than, my HTC is dead.

It doesn't switch on, it doesn't react on USB cable, it can't enter bootloader mode (keeping voice record button, while pushing reset button).

What I need to do to revive it?

Thanks in advance.

[Zecanilis]

Does the USB connects?
Try to reset the flash with MTTY.

[ClockEr]

No, when I connect it to USB, nothing happens. Neither orange LED blink, nor PC beeps like when USB device is found.

I tried to use mtty, but it does nothing. Apsolutelly nothing. I enter password and other commands, as sugested in some topics, but nothing happens.

I think that mtty doesn't see it at all. I can select COM3, regardless if HTC is connected to USB or not.

Next step?

[ClockEr]

Today I connected HTC on lab power source. When I try to switch it on, ampermetar shows that there is a flow of current through the circuit, but HTC remains switched off.

Anybody?