flashing problem

[largow7]

Hello,

I have a spv M2000 orange. I tried to update to windows mobile 6 I found here (http://forum.xda-developers.com/showthread.php?t=326532).

everything went fine at the beggining, but then activesync did the usual beep when disconnection occurs between pc and the smartphone. there was still the message saying "checking the information on your device... please don't disconnect... "I waited for a long time. but nothing happened then. still a black screen on my smartphone with "USB V2.07" written on it.
can anyone help me to find out a solution ?
thanks !

[Chef_Tony]

there is nothing lost or broken at this point, just try again using the instructions given here: http://wiki.xda-developers.com/index.php?pagename=HTC_Blueangel_WM6_WizzardUpgrad e1_WM2003SE0

there is probably something you forgot.

[largow7]

thanks Chef_Tony, you give me back some hope !
I tried to flash back to wm2003, and it works fine.
I will follow very closely all the steps of the procedure described on the page you pointed at, and tell you afterwards.

thx again.

[largow7]

ok it works fine.
I forgot to remove the memory card when flashing the first time.
thanks again for the help

[iattone]

Hi. I'm a new member. I need your help. I try to flash my PDA2K with HTC_BlueAngel_WM6.1_WWE_Final_by_Ham3r using WMDC on my Pc with Vista... but without put my device into Bootloader mode. The software is started, my PDA2K was blocked with "USB" on top of the screen and "V2.07" on the right bottom. After nothing more. I tried SR, HR, like the instruction on http://wiki.xda-developers.com/index...ade1_WM2003SE0, but nothing. My PDA2K is dead. On screen, nothing. What can i do? I can resurrect my PDA2K? Thank you

[Chef_Tony]

ok, first of all, that link does not work. secondly, yes! your Ba is not dead, it is in a state called "stuck in bootloader" which is due to your attempt to flash under windows vista, which does not work the same way as under win xp. because, during the upgrading process windows vista, being smarter than xp, discovers the device changes and downloads new drivers and installs them, which disconnects the device, and in the beginning of the upgrade process the upgrade utility tells you, never to disconnect the device, unless the process is finished, but since vista is doing it on its oqn, you can't do anything about it.

normally i would advise beginners to use a windows xp pc, i even heard of people managing to upgrade from vista, using a windows xp virtual machine, but in your case, with the device already stuck, you should have a deep look over -=this=- (http://wiki.xda-developers.com/index.php?pagename=HTC_Blueangel_WM6_WizzardUpgrad e4_Vista) and -=this=- (http://wiki.xda-developers.com/index.php?pagename=HTC_Blueangel_WM6_WizzardUpgrad e4_Vista_Pic) before even attempting to flash again. then you should think, whether you deleted wm2003's extrom before you started upgrading, probably not!
so to upgrade, you should flash wm2003 again, first.
the entire process of upgrading is described pretty good -=here=- (http://wiki.xda-developers.com/index.php?pagename=HTC_Blueangel_WM6_WizzardMain).
you say, you want to upgrade to wm6 from wm2003 and you use vista, then you get to all the steps needed for the first upgrade, please don't skip anything, please read carefully, if there is anything, you don't understand, please post back here, BEFORE destroying the device ;)

with best regards
Chef_Tony

[iattone]

Thank you for your help. I'm following step by step the instructions of your links, but my PDA2K don't work. It's appeared again "Serial" at the top and "V2.07" at the bottom, but the Perform Reset don't appeared (point 3 of Link: http://wiki.xda-developers.com/index.php?pagename=BA_Downgrade_WM5). Also WMDC don't see the devices either before or after the instruction on this link http://wiki.xda-developers.com/index.php?pagename=HTC_Blueangel_WM6_WizzardUpgrad e4_Vista_Pic ( i have never seen the boot option because my device don't make a perform reset). Help me....Thank you for you patience.
P.S.: I have also tried with my other pc with XP, but even ActiveSync see my PDA2K. However, in both my Pc, device manager show mobile device (microsoft usb sync).

[iattone]

I followed this procedure in this link http://forum.xda-developers.com/showthread.php?t=304408 with mtty.exe and my device is raised. Now is as good as new. Try with caution now. Thank you for everything.