PDA

View Full Version : Touch Diamond doesn't boot

Armaia
3rd August 2009, 03:08 AM
Hi everyone,

I've been trying to cook a WM6.5 in Portuguese (I used some files rom WM6.1PTG and I translated some others) with Visual Diamond Kitchen and in the cooking part all went well, I have the .ndh file generated and without errors.

Then I flash the Diamond and after the flashing is concluded the diamond makes itself a reboot and stops after the first boot screen with TouchDiamond and the red information about the versions.

I tried to do a hard restart, soft, remove and out again the batery without success.

Does anybody have the same problem?

I'll appreciate help.

Best Regards,

Armaia
pspeter
3rd August 2009, 05:07 AM
Do you removed "FWUPDATE"?
donsalari
3rd August 2009, 07:58 AM
Do you removed "FWUPDATE"?

:) that FWUPDATE troubled me a lot!!!!
Armaia
3rd August 2009, 10:38 AM
No, I didn't. Do you think that could be the problem? I,m going to try.

Thanks
coco1942
4th August 2009, 09:30 PM
Try to change the rom . Pull out the stylus , Press the reset button and hold the VOLUME DOWN and the right down button . After connect to pc
Armaia
4th August 2009, 11:43 PM
Hi,
I removed the FWDATE but the problem occurs in the same way.

AM
Claus72
5th August 2009, 11:07 AM
Hi,
I removed the FWDATE but the problem occurs in the same way.

AM

Try to restore first your original shipped rom and then reflash your own rom.
kaguras
5th August 2009, 05:37 PM
Hi All,

I have the same problem, I flashed MightygroovyROM, after first boot, it stops, there is only "Touch Diamond" on the screen. I tried hard reset but doesnt work. Since activesync connection couldnt establish, I couldnt do anything.

Anyone know another technique to connect without activesync ? or is there any other way to go back old rom any flaeshing a new rom ?

Best regards
Kag

Hi everyone,

I've been trying to cook a WM6.5 in Portuguese (I used some files rom WM6.1PTG and I translated some others) with Visual Diamond Kitchen and in the cooking part all went well, I have the .ndh file generated and without errors.

Then I flash the Diamond and after the flashing is concluded the diamond makes itself a reboot and stops after the first boot screen with TouchDiamond and the red information about the versions.

I tried to do a hard restart, soft, remove and out again the batery without success.

Does anybody have the same problem?

I'll appreciate help.

Best Regards,

Armaia