Need Help with Kaiser !!!! (Blank screen , green light)

[IP13]

Hi ! I have a problem with my Kaiser ! The screen is black, the device doesn't turn on ! But when i hold the power key & soft reset hole at the same time,
green light comes on, but the screen stays black ! Is there a way to make my kaiser working ? (Sorry for my english)

[Assface]

Remove battery and then press power button 30 seconds or more.

Worked for me.

[IP13]

Remove battery and then press power button 30 seconds or more.

Worked for me.
it doesnt work ! I think there is a problem with spl , because this problem appears after unsuccessful hard spl installing ! I don know how to fix this

[krouth]

Hi ! I have a problem with my Kaiser ! The screen is blank, the device doesn't turn on ! But when i hold the power key & soft reset hole at the same time,
green light comes on, but the screen stays blank ! Is there a way to make my kaiser working ? (Sorry for my english)

Not trying to oversimplify things, but is the device fully charged? Did you have any problems during the flash? Which SPL did you flash? Have you tried a hard reset? Can you get to the bootloader screen to verify the version of SPL installed vs. the version you tried to install?

Just a few questions to help us try to figure out what is going on. Take care!

[IP13]

Not trying to oversimplify things, but is the device fully charged? Did you have any problems during the flash? Which SPL did you flash? Have you tried a hard reset? Can you get to the bootloader screen to verify the version of SPL installed vs. the version you tried to install?

Just a few questions to help us try to figure out what is going on. Take care!

The device is fully charged ! The problem was when I tried to install hard spl ...the screen stuck and I made a reset ,after this the phone ca not be turned on and all I see is green light.
I can not get to bootloader screen , when i try to turn on the device the screen i black (blank) but the green light is on

[krouth]

The device is fully charged ! The problem was when I tried to install hard spl ...the screen stuck and I made a reset ,after this the phone ca not be turned on and all I see is green light.
I can not get to bootloader screen , when i try to turn on the device the screen i black (blank) but the green light is on

How are you trying to get to the bootloader screen? Have you fully read through this thread:

http://forum.xda-developers.com/showthread.php?t=533976

Finally, I would recommend downloading the original ROM and installing it. The ROM for the Tilt is here:

http://www.htc.com/us/SupportDownload.aspx?p_id=67&cat=2&dl_id=94

That is straight from HTC's website, and you might look to see if your specific phone is there. You should be able to download it, connect your phone with the USB cable and run the downloaded file from your computer to bring your phone back to it's original state.

If that works, I would then re-read the link above thoroughly and give it another shot. Hope this helps!

[IP13]

How are you trying to get to the bootloader screen? Have you fully read through this thread:

http://forum.xda-developers.com/showthread.php?t=533976

Finally, I would recommend downloading the original ROM and installing it. The ROM for the Tilt is here:

http://www.htc.com/us/SupportDownload.aspx?p_id=67&cat=2&dl_id=94

That is straight from HTC's website, and you might look to see if your specific phone is there. You should be able to download it, connect your phone with the USB cable and run the downloaded file from your computer to bring your phone back to it's original state.

If that works, I would then re-read the link above thoroughly and give it another shot. Hope this helps!
Active sync doesnt recognize my Kaiser! :(

[krouth]

Active sync doesnt recognize my Kaiser! :(

When you try to run the original HTC ROM installation program (from my previous post) with your phone connected - does it recognize your Kaiser?

[IP13]

When you try to run the original HTC ROM installation program (from my previous post) with your phone connected - does it recognize your Kaiser?

no,it doesnt recongnize my kaiser ! when I connect my kaiser via USB Windows says that i have conected a "ZTE USB Modem 6000 CDMA 1x"

[krouth]

no,it doesnt recongnize my kaiser ! when I connect my kaiser via USB Windows says that i have conected a "ZTE USB Modem 6000 CDMA 1x"

I am not asking what Windows thinks you have connected, or whether or not ActiveSync sees the device. What I am asking is: When you run the original HTC ROM installation program:

"RUU_Kaiser_CINGULAR_WWE_3.57.502.2_radio_sign_25.8 8.40.05_1.65.21.18_Ship.exe"

downloaded from HTC's website, is that program able to see your phone and go through the installation process?

[delower10]

no,it doesnt recongnize my kaiser ! when I connect my kaiser via USB Windows says that i have conected a "ZTE USB Modem 6000 CDMA 1x"

Uninstall Ur Active synce And Install Again .

Then Put Ur Phone In Bootloader Mode I Hope Work Fine

CHK And Post Result

[IP13]

I am not asking what Windows thinks you have connected, or whether or not ActiveSync sees the device. What I am asking is: When you run the original HTC ROM installation program:

"RUU_Kaiser_CINGULAR_WWE_3.57.502.2_radio_sign_25.8 8.40.05_1.65.21.18_Ship.exe"

downloaded from HTC's website, is that program able to see your phone and go through the installation process?

I cant install this rom because it shows me an error : "ERROR [260] CONNECTION
The Update Utillity cannot connect your PDA Phone . Please check that your USB cradle/cable is connected properly between the PC and your PDA phone .

Chech the following :
1.The PDA Phone is connected to the USB cradle/cable.
2.The USB cradle/cable is connected to the PC "

I have allready checked the cable (it works with my other PDA)

[IP13]

Uninstall Ur Active synce And Install Again .

Then Put Ur Phone In Bootloader Mode I Hope Work Fine

CHK And Post Result
I cannot acces bootloader mode , when I am pressing keys to acces bootloader mode the phone screen is still black /blank .

[krouth]

I cannot acces bootloader mode , when I am pressing keys to acces bootloader mode the phone screen is still black /blank .

To access bootloader, you should hold down the camera button (on right side of phone) and the use the stylus to press the reset button (on bottom of phone.) When the phone goes blank, release the camera button.

When you do this, do you still get the blank/black screen?

Also, did you follow EACH step in the following thread:

http://forum.xda-developers.com/showthread.php?t=433835

[IP13]

To access bootloader, you should hold down the camera button (on right side of phone) and the use the stylus to press the reset button (on bottom of phone.) When the phone goes blank, release the camera button.

When you do this, do you still get the blank/black screen?

Also, did you follow EACH step in the following thread:

http://forum.xda-developers.com/showthread.php?t=433835

Yes ! I also get the blank screen after following all this steps !

[krouth]

Yes ! I also get the blank screen after following all this steps !

I am not sure.... I have done some searching and ran across this thread:

http://forum.xda-developers.com/showthread.php?t=423486

It has numerous posts about problems people have experienced flashing - maybe you might get some insight there - or at least post your question there where more people might be monitoring the thread. Good luck!

[Pisca]

Please take your issue to the right place, better than open a new thread, I sugest

http://forum.xda-developers.com/showthread.php?t=433835

Your situation should be taken by the right guys, not just gessing if this or that might solve the situation, male a post there

Also have a look at the sticky on the top, try to get Dave Shaw help

[IP13]

THx I will try to ask there ....

[tyler51773]

Okay if you can't access the boot loader then you need to go higher up. I think the chain is Radio Rom, then SPL, then OS. Basically your SPL is gone, that is why your screen is black and you can't get into the boot loader --- cause its gone. So no duh, it can't load the OS. So, your only hope is that your radio rom is working so you can access the phone via cmd interface programmed within it.I really don't know what i'm talking about, but I've bricked my phone too and with some guidance (er explicit instructions in chat) I was (er she was) able to fix it [my situation was far more complicated with a "security locked" device, and a "radio from hell"]. Your key words are frankenkaiser. which you can find here:
http://forum.xda-developers.com/showthread.php?t=394584

Good luck, if you can get into the oemsbl I'm sure your in business. If your feeling nervous bust out the paypal and head to irc.freenode.org #xda-devs {albeit someone will likely help you without the donation but for real your going to hold someone up for an hour or two you should throw them atleast 20$ to save u 200$ }

[IP13]

Okay if you can't access the boot loader then you need to go higher up. I think the chain is Radio Rom, then SPL, then OS. Basically your SPL is gone, that is why your screen is black and you can't get into the boot loader --- cause its gone. So no duh, it can't load the OS. So, your only hope is that your radio rom is working so you can access the phone via cmd interface programmed within it.I really don't know what i'm talking about, but I've bricked my phone too and with some guidance (er explicit instructions in chat) I was (er she was) able to fix it [my situation was far more complicated with a "security locked" device, and a "radio from hell"]. Your key words are frankenkaiser. which you can find here:
http://forum.xda-developers.com/showthread.php?t=394584

Good luck, if you can get into the oemsbl I'm sure your in business. If your feeling nervous bust out the paypal and head to irc.freenode.org #xda-devs {albeit someone will likely help you without the donation but for real your going to hold someone up for an hour or two you should throw them atleast 20$ to save u 200$ }

Thx man , appreciate this !!

[msd24200]

why have you started 2 threads on this forum about the same problem?