PDA

View Full Version : I-mate JAM, failed Upgrading problem.. HELP


sikuri
9th November 2009, 02:39 PM
I have a problem with my I-Mate JAM, It loads the OS.. but after everything Installs it converts to the BootLoader screen, and remains unuseable.

If I rest the phone, it loads straight to the Bootloader screen, but if I take off the Battery cover, leave it for a few seconds, then replace it and turn the phone on... It will load the OS setup again, but go back to the BootLoader.

So how can I fix this, and what must I do? Please help me ASAP. The Rom/OS is Windows 2003 SE.

Thanks

Sikuri

rabi347
12th February 2011, 03:35 AM
i have the same issue, the os loads, starts installing and goes right back to the boot loader. I can not install anything, if I try to upgrade, it starts but goes back to bootloader and gets stuck.

Help will be much appreciated.

Hakim Rahman
12th February 2011, 01:25 PM
i have the same issue, the os loads, starts installing and goes right back to the boot loader. I can not install anything, if I try to upgrade, it starts but goes back to bootloader and gets stuck.

Help will be much appreciated.


Did you unlock your device by SDA ApplicationUnlock before upgrading ?? :confused:
try reconnect with usbActivsync and run SDA ApplicationUnlock after that make sure the device go to the boot loader and flash back....

rabi347
13th February 2011, 11:35 PM
I did the SDA unlock, it says unlocked and asks me to reboot. After rebooting it goes to bootloader again.

Hakim Rahman
14th February 2011, 05:58 AM
I did the SDA unlock, it says unlocked and asks me to reboot. After rebooting it goes to bootloader again.

if so now remove the battery and sim card from the device, wait until about 10 minutes after that replace the batteries and make sure the device go to bootloader and reflash....