[Q] XXUFNG4 and problems with Bluetooth

222 posts
Thanks Meter: 28
By Zelych, Senior Member on 18th August 2014, 10:26 PM
Post Reply Subscribe to Thread Email Thread
Hi, I found this thing, I tried now lately 2 ROM (Dr.Ketan v9 and X-TREME v4) based on the official firmware XXUFNG4 and both showed me the problem with disconnecting Sony SmartWatch SW2.
I do not know if it's any systemic "property" or somehow reduce the scope for bluetooth? I wear a watch on his left hand and a phone in my case right on the belt.
Restart (both phone and watch) did not help.
He did not meet anyone with the same problem? (N7100)
Last edited by Zelych; 18th August 2014 at 10:50 PM.
19th August 2014, 03:36 PM |#2  
Zelych's Avatar
OP Senior Member
Flag Trutnov
Thanks Meter: 28
So I think I found the solution to my problem.
It is not perfect, but I watch it does not disconnect.
If you set the visible BT, respectively. time limit visibility to none, so the watch will stop disconnecting. Except that the patch phone's visibility is greater consumption.
23rd August 2014, 06:47 PM |#3  
Zelych's Avatar
OP Senior Member
Flag Trutnov
Thanks Meter: 28
Info 2
I tried to Blutooth range fix from Dr. Ketan on X-TREAME ROM problem with bluetooth and it worked, but again there were problems other.
See. click here.
28th August 2014, 04:18 PM |#4  
Junior Member
Thanks Meter: 0
Can't fix the BT problem after flash NG4 based roms (tryied Ketan v10 and Phanton v9). When try to connect to my Gear1, the ConnectionManager as stopped.
Even flashing the BT range fix doesn't work for me.
Clean install without restore anything of sammyaccount, doesen't work too
Post Reply Subscribe to Thread
Previous Thread Next Thread
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes