So this morning, on my ATT GS4 NC1, I went into safestrap and created a new installation on rom slot 1. I guess that's what you call it. I pressed rom slot 1, then wiped, then installed hyperdrive. The install went fine and afterwards, I installed the NC1 module.zip and the SU zip file (both found in the "all things att" thread under "NC1 instructions".
Once it was done, I rebooted but what it did was boot to the regular stock rom. All my screens were the same (app placements, settings, etc) but I noticed I had no cell signal. I went to settings>mobile network and it said something about needing to install a sim card. Sorry I can't remember exactly what it said.
Anyhow, I went into safestrap, rebooted and then activated the stock rom slot and booted. Everything is fine.
What happened? Any ideas as to what happened? As of right now, I am running on the stock slot using the stock rom pending suggestions from you all.
Thanks!
Once it was done, I rebooted but what it did was boot to the regular stock rom. All my screens were the same (app placements, settings, etc) but I noticed I had no cell signal. I went to settings>mobile network and it said something about needing to install a sim card. Sorry I can't remember exactly what it said.
Anyhow, I went into safestrap, rebooted and then activated the stock rom slot and booted. Everything is fine.
What happened? Any ideas as to what happened? As of right now, I am running on the stock slot using the stock rom pending suggestions from you all.
Thanks!