Remove All Ads from XDA
Find Your Device:
Or Continue to Thread: [ROM] Flytouch2 Froyo [Stragul…
23rd November 2011, 07:26 AM |#2072  
Junior Member
Flag Pitesti
Thanks Meter: 4
Thumbs up Hardware reflash
1-Desolder the FT3 chip
2-Was able to read the MX29LV800CB or MX29LV800CTTC and programmed with u-boot-nand.bin
3-Soldered the programmed MX29LV800CTTC back to the broken Pad, reboots with screen test...
4-Now you should put the tablet in flash mode, to use IUW (or burntools)...
5-Connect the tablet with the usb cable to the PC
6-Press and hold menu + power.

- Sholdering iron;
- Willem programmer with a TSOP48 (8/16bit) adapter

- Do not use hot air ... processor is too close to epromm!!! (If you do not want to do reflow after)
- Use flux and solder on all pins on one side and gently lift the eprom ...
- Pay attention to short-circuits...

I tried two epromm MX29LV800CB (programmed with u-boot-nand.bin flytouch 2) and MX29LV800CTTC
(programmed with u-boot-nand.bin flytouch 3). Both have worked for me ...
Attached Thumbnails
Click image for larger version

Name:	Dezlipire eprom.JPG
Views:	584
Size:	57.1 KB
ID:	792290   Click image for larger version

Name:	Relipire eprom.JPG
Views:	538
Size:	87.4 KB
ID:	792291   Click image for larger version

Name:	Butare.JPG
Views:	511
Size:	66.2 KB
ID:	792292   Click image for larger version

Name:	Wileem.jpg
Views:	482
Size:	91.3 KB
ID:	792293   Click image for larger version

Name:	Comparare Bin.JPG
Views:	425
Size:	90.4 KB
ID:	792294