[DEV] Discussion about USB-TTL UART JIG
I've created this thread to gather all the info and doubts about UART JIG (also so <I> don't pollute OpenFIMG's thread
Readings of interest:
Vcc (Pin 1) -> Disconnected.
D- (Pin 2) -> RXD.
D+ (Pin 3) -> TXD.
ID (Pin 4) -> Connected to GND with 523k ohm attached.
GND (Pin 5) -> GND
Baud rate: 115200, 8N1. No control flow.
Boot from the SBL:
How to get output from kernel
If you like my work, don't forget to hit the thanks button, and consider a donation
. I can't buy beer yet, but my college fund will thank you