[GUIDE][VIDEO] Moto X - Return to 100% stock (using RSD Lite)
NOTE, YES, THIS IS A LONG DRAWN OUT VERSION OF WHAT IS ACTUALLY VERY VERY QUICK PROCESS. This is for reference only. I know there are a few people out there just like me who probably had a few small hickups getting back to stock with the firmware. This is to help "spoon-feed" the instructions to you.
I assume you already have adb drivers if you're even here.....otherwise get them from the latest sdk here:
Moto Drivers (Motorola Device Manager):
RSD Lite (I used version 6.1.5):
- Extract and use 6.1.5
thanks to Skrilax_CZ and Firmware Team
My Setup: Windows 8 machine <--obvious driver issues as usual
My Device: VZW Moto X
Step One - Download and install RSD Lite. At the moment, I can't find where I got mine from, so anyone who wants to add a proper link to it would be appreciated. I used version 6.1.5 and it worked fine.
Step Two - proper driver installation. If you're like me, you probably at one point got drivers quasi-working but here's what I did that worked - download and install "Motorola Device Manager" and it *should* give you the proper drivers. This was necessary (maybe) because I could get adb to recognize my device, as well as fastboot, however RSD refused to see it. This install fixed that.
Step Three - download and install the proper firmware for your device. NOTE: You MUST MUST MUST choose the right firmware for your device or you will FUBAR your phone.....not my responsibility.
Step Four - Unzip your firmware zip file, open it up through the layers and find the file "VZW_XT1060_4.2.2-13.9.0Q2.X-116-MX-17-53_CFC_1FF" or whatever version/carrier/build number file yours is, its the XML Document file. Right click -> Open with.. -> Notepad/word editor/XML Editor/wordpad and find the line:
<step operation="getvar" var="max-download-size" />
^^^You need to select this entire line and just delete it out of the file. This is the line that gives fastboot flash error. Select it, delete it, then resave the file an exit out of it. Done.
NOTE: This is required or the firmware flash will immediately fail giving a "failed flashing process. Unknown fastboot command. (getvar)"
-For the sake of security, and not messing with important files, I'd actually recommend zipping the file back up after this and keeping as your final version (once you've confirmed yours works correctly)
Step Five - Plug in phone, enable USB debugging, then "adb reboot bootloader" - this will boot you into fastboot mode so RSD will recognize your phone
Step Six - Run RSD Lite - note that some people have had trouble and have to right-click run as administrator. In RSD Lite, make sure phone shows up in slot 1 - mine shows up, under Model, just says fastboot, USB port type, info N/A, important part is that it shows as Connected in status. Select the three-dot browse file button, then you can go down into the unzipped file you created of the XML folder, and select the XML file that we just edited earlier (or select the rezipped package). Select open and flash. (or decompress and flash)
Step Eight - Profit