Or Continue to Thread: [Q] OTA 4.4.2 update failed, S…
Find Your Device:
29th June 2014, 07:15 AM   |  #1  
OP Junior Member
Thanks Meter: 0
 
2 posts
Join Date:Joined: Dec 2012
I did the verizon pushed update to 4.4.2 today on my SCH I535 S3 which was totally stock with encryption. After the install finished "upgrading apps" it then did a re-boot and asked for my encrypt pin then showed the outline Andy. Then after a couple of vibrations it re-boot again and will continue this cycle until battery is removed. After sitting on the phone for several hours and conversing with Samsung and Verizon they pointed me to Samsung Experience in a Best Buy and if that doesn't work I have to send it to Samsung for re-flash. They said they couldn't get their software to recognize my phone. The guy there recommended using odin to download a stock rom.

I have downloaded odin 3.07 and have downloaded a 4.3 stock rom. I set up odin with auto reboot and F. reset time checked and nothing else. I select the .tar.md5 in the bootloader and here is my odin output:

<ID:0/004> Added!!
<OSM> Enter CS for MD5..
<OSM> Check MD5.. Do not unplug the cable..
<OSM> Please wait..
<OSM> I535VRUCNC1_I535VZWCNC1_HOME.tar.md5 is valid.
<OSM> Checking MD5 finished Sucessfully..
<OSM> Leave CS..
<ID:0/004> Odin v.3 engine (ID:4)..
<ID:0/004> File analysis..
<ID:0/004> SetupConnection..
<ID:0/004> Initialzation..
<ID:0/004> Get PIT for mapping..
<ID:0/004> Firmware update start..
<ID:0/004> sbl2.mbn
<ID:0/004> NAND Write Start!!
<ID:0/004> sbl3.mbn
<ID:0/004> aboot.mbn
<ID:0/004> FAIL! (Auth)
<OSM> All threads completed. (succeed 0 / failed 1)

My phone says:
ODIN MODE
PRODUCT NAME: SCH-I535
CURRENT BINARY: Samsung Official
SYSTEM STATUS: Official
QUALCOMM SECURE BOOT: ENABLE
BOOTLOADER AP SWREV: 2
SW REV CHECK FAIL : Found 2 > Binary 1

Please tell me how to recover my phone. I am new to this so give me detail please.