I installed cm9 after using cm7 and cant get the four buttons on the phone to light up. They are accessible but not illuminated. has anyone else encountered this problem.
Also I was wondering if the Cm7 uses more battery than cm9
I believe in the advanced brightness settings under CMSettings you can do just that. Whenever I run a CM rom, I always go to the brightness settings under edit Other Levels and set all the softkey values on the far right column to 255 so they're always the same brightness and look nice. I like the sheen they have, but I can only see it when they're close to full brightness.Ive been using the dinc2 since last July and I got used to the buttons to the point that I noticed they didn't light up, but until I saw this post, I never considered it a "problem". Since I knew where they were and didn't need to see them to use them. If they ever do "fix" this issue I hope they allow for a settings option to keep them turned off. I actually enjoy them off, in my mind its just one more security feature. I know when my wife tries to use my phone she needs to see them, and since recently rooting to CM9 I don't want her bricking my phone. Because of the unlit buttons she has stopped using my phone (she uses some cheap AT&T phone, refuses to switch to Verizon). Just throwing my opinion in the mix. Thanks for the post as well I wasn't sure it was intentional or not.
Thank you ....as I am new to a rooted phone and this forum I didn't know those adjustments were available...learn something new everyday ......
Does cm9 drain the battery alot quicker or is it unnoticeable
I believe in the advanced brightness settings under CMSettings you can do just that. Whenever I run a CM rom, I always go to the brightness settings under edit Other Levels and set all the softkey values on the far right column to 255 so they're always the same brightness and look nice. I like the sheen they have, but I can only see it when they're close to full brightness.
If you did the opposite, set all the values to 0 and then click Save and Apply Values at the top of that screen, they should, theoretically, never turn on.
I installed cm9 after using cm7 and cant get the four buttons on the phone to light up. They are accessible but not illuminated. has anyone else encountered this problem.
Also I was wondering if the Cm7 uses more battery than cm9
I believe in the advanced brightness settings under CMSettings you can do just that. Whenever I run a CM rom, I always go to the brightness settings under edit Other Levels and set all the softkey values on the far right column to 255 so they're always the same brightness and look nice. I like the sheen they have, but I can only see it when they're close to full brightness.Ive been using the dinc2 since last July and I got used to the buttons to the point that I noticed they didn't light up, but until I saw this post, I never considered it a "problem". Since I knew where they were and didn't need to see them to use them. If they ever do "fix" this issue I hope they allow for a settings option to keep them turned off. I actually enjoy them off, in my mind its just one more security feature. I know when my wife tries to use my phone she needs to see them, and since recently rooting to CM9 I don't want her bricking my phone. Because of the unlit buttons she has stopped using my phone (she uses some cheap AT&T phone, refuses to switch to Verizon). Just throwing my opinion in the mix. Thanks for the post as well I wasn't sure it was intentional or not.