Do you have WiFi? If so, it probably isn't due to rtl8150 - every ROM you've ever installed (including mine) loads it (and every one claims to be the same version).
Well I couldn't check if I had wifi since the touchscreen didn't work, and stupidly I didn't even try to do it over the command line. I shall try it again later.
EDIT: I guess you're right. rtl8150 is a module and is loaded upon boot. I shall dig further.
---------- Post added at 05:23 PM ---------- Previous post was at 04:43 PM ----------
Well I couldn't check if I had wifi since the touchscreen didn't work, and stupidly I didn't even try to do it over the command line. I shall try it again later.
Nope, you're right. This is what happens when I turn on the wifi on the Ainol ROM:
Code:
root@nostromo:~# adb shell "svc wifi enable"
root@nostromo:~# adb shell dmesg
[cut]
<7>[ 289.740000] sw_usb_enable_hcd: usbc_num = 2
<7>[ 289.740000] [sw-ehci2]: sw_usb_enable_ehci
<7>[ 289.750000] [sw-ehci2]: probe, pdev->name: sw-ehci, pdev->id: 2, sw_ehci: 0xc086d6e8
<7>[ 289.760000] [sw-ehci2]: open clock
<7>[ 289.780000] [sw-ehci2]: Set USB Power ON
<6>[ 289.780000] sw-ehci sw-ehci.2: SW USB2.0 'Enhanced' Host Controller (EHCI) Driver
<6>[ 289.790000] sw-ehci sw-ehci.2: new USB bus registered, assigned bus number 2
<6>[ 289.810000] sw-ehci sw-ehci.2: irq 40, io mem 0xf1c1c000
<6>[ 289.830000] sw-ehci sw-ehci.2: USB 0.0 started, EHCI 1.00
<6>[ 289.830000] hub 2-0:1.0: USB hub found
<6>[ 289.830000] hub 2-0:1.0: 1 port detected
<7>[ 289.840000] [sw-ohci2]: sw_usb_enable_ohci
<7>[ 289.850000] [sw-ohci2]: probe, pdev->name: sw-ohci, pdev->id: 2, sw_ohci: 0xc086d7f8
<7>[ 289.850000] [sw-ohci2]: open clock
<6>[ 289.880000] sw-ohci sw-ohci.2: SW USB2.0 'Open' Host Controller (OHCI) Driver
<6>[ 289.880000] sw-ohci sw-ohci.2: new USB bus registered, assigned bus number 3
<6>[ 289.890000] sw-ohci sw-ohci.2: irq 65, io mem 0xf1c1c400
<6>[ 289.960000] hub 3-0:1.0: USB hub found
<6>[ 289.970000] hub 3-0:1.0: 1 port detected
<7>[ 289.970000] rtw driver version=v3.4.1_3418.20120217
<7>[ 289.980000] Build at: Mar 6 2012 18:23:11
<7>[ 289.980000] ##########rtw_suspend_lock_init ###########
<6>[ 289.990000] usbcore: registered new interface driver rtl8192cu
<7>[ 294.400000] +rtw_drv_halt
<7>[ 294.400000] ##########rtw_suspend_lock_uninit###########
<6>[ 294.410000] usbcore: deregistering interface driver rtl8192cu
<7>[ 294.410000] -rtw_drv_halt
<7>[ 294.420000] sw_usb_disable_hcd: usbc_num = 2
<7>[ 294.420000] [sw-ehci2]: sw_usb_disable_ehci
<7>[ 294.430000] [sw-ehci2]: remove, pdev->name: sw-ehci, pdev->id: 2, sw_ehci: 0xc086d6e8
<6>[ 294.430000] sw-ehci sw-ehci.2: remove, state 1
<6>[ 294.440000] usb usb2: USB disconnect, device number 1
<6>[ 294.450000] sw-ehci sw-ehci.2: USB bus 2 deregistered
<7>[ 294.450000] [sw-ehci2]: close clock
<7>[ 294.460000] [sw-ohci2]: sw_usb_disable_ohci
<7>[ 294.460000] [sw-ohci2]: remove, pdev->name: sw-ohci, pdev->id: 2, sw_ohci: 0xc086d7f8
<6>[ 294.470000] sw-ohci sw-ohci.2: remove, state 1
<6>[ 294.470000] usb usb3: USB disconnect, device number 1
<6>[ 294.480000] sw-ohci sw-ohci.2: USB bus 3 deregistered
<7>[ 294.490000] [sw-ohci2]: Set USB Power OFF
<7>[ 294.490000] [sw-ohci2]: close clock
Last edited: