[Q] How can I flash PRL to phone on CM11?

mvmacd · Feb 10, 2014

My carrier is PagePlus [MVNO off Verizon], I flashed my phone number, MIN, [verizon] PRL, etc in CDMA Workshop on the latest stock ROM.

But on CM11, it doesn't have the diagnostic mode for CDMA Workshop, and I do not want to have to go back to the stock ROM in case I ever need to update my PRL [For one, if I roam on Sprint, it charges a lot, and I'm not sure if it would say "Roaming" if I went to sprint, since it says it's connected to "Sprint" (but it's really Verizon)..].

buddahj · Feb 10, 2014

Have you tried using qpst? That's what I used to change my prl?

http://xdaforums.com/showthread.php?t=1145111

mvmacd · Feb 10, 2014

buddahj said:
Have you tried using qpst? That's what I used to change my prl?

http://xdaforums.com/showthread.php?t=1145111

If I could dial ##3424# on AOSP roms, I wouldn't have started this thread.

But I can't, because I'd have to flash Sense, defeating the whole purpose of the thread (read title closely). And I happen to hate sense, and love AOSP. So that is why I started the thread.

Sent from my EVO using xda app-developers app

buddahj · Feb 10, 2014

My bad bud. Since I haven't run an AOSP rom before, I was unaware you couldn't do that. A quick Google search found these. Maybe one of them will work. Worst case, couldn't you just flash back to sense, change your prl and then go back to the rom you're running now? I know it'll take extra time, but you may not have a choice. Good luck.

http://xdaforums.com/showthread.php?t=1871352
or
http://xdaforums.com/showthread.php?t=1034373

mvmacd · Feb 11, 2014

buddahj said:
My bad bud. Since I haven't run an AOSP rom before, I was unaware you couldn't do that. A quick Google search found these. Maybe one of them will work. Worst case, couldn't you just flash back to sense, change your prl and then go back to the rom you're running now? I know it'll take extra time, but you may not have a choice. Good luck.

http://xdaforums.com/showthread.php?t=1871352
or
http://xdaforums.com/showthread.php?t=1034373

right, ok, thanks I'll give it a try after I boot [I'm backing up in recovery, then going to update my cm11].
update: neither one worked

gunfromsako · Feb 23, 2014

You would need a script to put your phone in DIAG mode. The s3 had one at one point but its not compatible. So as of right now the only ways is to flash a sense ROM.

Sent from my SPH-L710 using Tapatalk

Topics

Topics

[Q] How can I flash PRL to phone on CM11?

mvmacd

Senior Member

buddahj

Senior Member

mvmacd

Senior Member

buddahj

Senior Member

mvmacd

Senior Member

gunfromsako

Senior Member

Similar threads

New posts